Replacement Motor For Landing Gear on 2008 Heartland Razor Toy Hauler

Question

Question:

My motor for my front jacks went out on my trailer. Its a 2008 heartland razor fifth wheel toy hauler. Model is UL#MQ887. BPI-12-126. Which motor do I need?

asked by: Chris C

0

Expert Reply:

The replacement motor for your landing gear is # LG-142178.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The motor very well might need to be replaced on your 2008 Keystone Everest 5th Wheel Trailer, but there are a few other possible reasons for its slow operation that I recommend checking first. A slow and weak motor can also be caused by low battery…

view full answer...

Answer 2

Hey Tyler, so the difference is the amount of motors that each has. The Lippert PSX2 has two and the Lippert PSX1 like the part #LC298707 has a single motor. The foot print and mounting etc. is exact same so this will fit and work great in place of…

view full answer...

Answer 3

Trailer stabilizer jacks like #TJSCHD-24 are not designed to be used to lift a trailer and hold it up for maintenance. Their purpose is to stabilize the trailer while it's parked and no more. What you're looking for is a jack to hold the…

view full answer...

Answer 4

The SAE number of a trailer light isn't always the best way to pick out a replacement light since that isn't a part number. But most likely you are looking for a #MC32RB which measures 4 inch by 2 inch. If not, check out the link I attached…

view full answer...

Answer 5

Goodyear Endurance trailer tires are the only USA made trailer tire out there. In the size of 225/75-15 that you referenced we have a Goodyear part #724857519 which is definitely your best choice. These have the best tread design, warranty, speed…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Replacement Motor For Landing Gear on 2008 Heartland Razor Toy Hauler

Product Page this Question was Asked From

Continue Researching