Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Getting your trailer level shouldn’t take all afternoon. This electric landing gear set runs nearly twice as fast as the older 80-RPM base model, cutting down the time you spend holding the switch. With a total 37" lift—21" of screw travel plus 16" from the drop leg—there’s plenty of range to handle uneven ground or tall setups. When power isn’t available, the included manual hand crank keeps you moving without delay.
Each leg in this kit can take on part of a big load with ease, giving a combined capacity of 6,000 lbs. It’s made from sturdy steel and finished with a corrosion-resistant black powder coat that resists rust from road spray and rain. Large rectangular footplates—5" long by 7-15/16" wide—spread the weight over soft surfaces, keeping your trailer steady and preventing sink-in on dirt or gravel pads.
Matching new landing gear to existing frame brackets is simple thanks to standard weld stop spacing of 15-1/2" inside-to-inside (17-1/2" outside-to-outside). An extendable cross shaft adjusts from 41" to 71" so you can line the legs up perfectly across different frame widths. If your old brackets don’t match, new hardware and mounting brackets are included for a solid bolt-on or weld-on install.
The fuse-protected wiring keeps the system safe from shorts and works seamlessly with typical electrical setups. The motor is ignition protected for safe mounting near propane systems. If power cuts out, switch to the manual crank and you’re still able to raise or lower without disassembly—no need to cancel your trip over a blown fuse.
Instead of cranking endlessly, each jack uses gravity to extend its drop leg for quick ground contact before final lift. Once down, the rectangular footplates stay planted, keeping your trailer from rocking while parked or during loading and unloading. It’s a practical upgrade that turns setup from a chore into a short step before relaxing at camp.
Note: Do not use landing gear to lift your trailer or RV during tire changes or service work, because doing so will exceed the capacity of the landing gear.
Customer Satisfaction Score:
91% were satisfied with this product
9% of customers were not satisfied
Ratings & Reviews
Customer service to order to correct parts was great! Order arrived quickly and, as with all other reviews, the box the order came in was terrible. However, all parts were there and everything fit and worked perfectly!
Landing gears shipped extremely fast and worked perfectly. Was an exact match for the ones I was replacing everything fit perfect. Have had for a year now and seem to be holding up very well so far.
Info on the etrailer site gave me confidence that I bought the correct landing gear for my RV + and it was perfect! Order even arrived two days early.
It took about a week for me to receive the landing gear. I paid extra for express delivery although I actually received a day later than they said I would by regular delivery. The box was torn up and I was missing some parts but made it work by using some of my old parts. Other than that, everything was okay……at least it fit.
Landing jacks came in a box that was in rough shape. Nothing was wrapped and all metal pieces were stacked and scratched up including the motor.
Had to modify landing jacks to be able to bolt on to the already installed mounts. Other than that everything fit as it should. Due to the price and how poorly this system shipped. I would not recommend.
I ordered my landing legs complete package Lippert LC 333964 for my 2007 Keystone Raptor 299 m. It had everything to replace my complete landing legs. Etrailer is the best company I’ve ever did business with. Shipping was real fast. They returned emails within minutes. They are my go to trailer parts store. Thank you so very much. Les
Had a slight problem with the switch being damaged during shipping but etrailer sent a new one right away. Thanks for the great response!
It came quick and installed very easy definitely recommended them, they were great company to work with
The item was delivered on time. I checked and there were no missing parts. The landing gear set fit perfect and appears to be well made. Installation instructions were not included. Whether or not you are experienced with installation of this system, I believe instructions should always be included.
My fifth wheel landing gear needed replacement. One side would not work. No information on my unit. However, Rochelle of E-Trailers did research to determine a replacement unit. Was shipped to California in 3 days and I installed. Perfect fit !! Thank you Rochelle. Awesome Customer service and great quality.
Not a hard project for someone younger than me. It seems to work and interchange with the old one. I have yet to try the hand crank. I had to jack trailer up in order to work on it with floor jack and blocks. I'm not sure if the hand crank would pick it up. However, I am happy with the product and will get it a full blown test in June 2020 to see if it holds up. I don't expect any problems.
Purchased for my 2010 Keystone Montana Mountaineer 285 RLD. The original Jack Leg collapsed. I ordered this set to replace the complete Jack Leg System. I upgraded the capacity for added assurance and they fit perfectly. The system runs a little bit slower than the original but that is caused by the different gear ratio for the increased capacity. A few extra seconds of time is an easy trade off for the increased capacity security. A great product from a great company.
This landing gear has worked great. Unfortunately it was a bigger job than we were willing to undertake but luckily found a mobile repair service to install it for us. We have had no problems since then.
I would give five stars if the product came with instructions and packaged better. Box came like it was taped up by 2 year old. Parts loose and hardware loose. Jacks did work fine.
Katrina B.
4/13/2022
I have some installation instructions in the link below.
Helpful Links
file:C:UsersKatrina.BunchDesktopGround%20Control%C2%AE%203.0%20Landing%20Gear%20Owner's%20Manual.pdf
The landing gear worked perfectly as a direct replacement to my existing landing gear. One of the legs of the existing landing gear had failed so I decided to replace the entire unit. Everything worked great. Although it wasn’t very difficult to figure out how things were to be put together, there were no installation instructions. It took about two hours of wrench time plus an hour of unpacking, setup, and clean up to replace the entire unit.
Great replacement of landing gear that was no longer working correctly on our ole trailer. Was a pretty simple replacement once logistics of supporting trailer and accessing with generator compartment partially in the way. I no longer have the fear of be able to re-hitch if I need to lower for leveling purposes. Thanks etrailer you guys have been great with all my DIY trailer projects.
Parts arrived promptly and in good condition. Tracking kept us informed about delivery so we could still enjoy camping. Phone assistance was knowledgeable and concise. Will continue to ship etrailer. Thanks!
Shauna
12/8/2022
Our landing gears are doing great. We have been enjoying our tour of the states
I installed the jacks on my 23 ft. 5th wheel trailer, which was very simple and ran the electric wires direct to my battery compartment. The jacks work fine but are a bit too noisy for my liking. Not sure if all are this noisy but they do the job.
Edward T.
4/7/2023
Still very noisy gears but it works.
Easy to install and great product! Etrailer got it here on time as usual!
I really can't say a lot about the product quality at this time since I just got it installed. It was (I believe) drop shipped to me from the factory. When I received and installed the land gear assembly it kept binding regardless of if I was raising or lower the landing gear rendering it unusable. I contacted the folks at etrailer and was helped by their technician Wayne H. With his help we were able to discover the problem and that was that the factory sent me two leading landing gear legs instead of a (1) leading leg and one following leg. etrailer sent me a replacement following landing gear leg and I installed it today. Once again the electric landing gears on my 5th wheel worked just like they did when the trailer was new. I will definitely be doing business with etrailer in the future and do recommend them to anyone needing parts for a trailer.
Ernie H.
11/3/2017
Sold the trailer to my son and his family last spring. Up till that time I experienced no problems and he has not indicated any problems with the landing gear. Cant say enough about the support provided by your company to fix the original manufacture mistake of the kit having two leading legs originally sent to me. I would definitely recommend your company to my friends and family.
If you are installing this on a Dutchman Denali that’s around the year 2007 the lead leg is an absolute pain in the butt to change. The propane set up is right in the way of the bolts that need to come out.
New landing gear for my 2012 Cougar 5th wheel. Delivered on time (box was pretty beat up) all the parts were there and it was a perfect fit! Installed it myself in about 1 1/2 hours
Bonus, it was cheaper than at Amazon.
Highly recommend e
trailer !
Customer service was awesome. Parts arrived and appear to be as ordered. I haven't had a chance to install them yet so no review on how they actually fit and work.
Received the Kit in about four days (5 Stars for etrailer). The shipping container was severely damaged (2 stars for UPS), but at least it arrived. Did not appear any parts were missing. I ordered this kit because it was less expensive for the complete kit then to replace both landing gear legs separately. I left the 5th wheel attached to the truck and removed the old landing gear, gearbox, and motor prior to the arrival of the new system. Keep all your parts. The new kit arrived and was very easy and straight forward to install. However the tubular steel expansion rod that connects both landing gear legs was too short. I had to use the my old connection rod. Also the spacer used for the inside of the large side of the connection rod was not included with the kit. Had to use the old spacer in the old connecting rod. I used my old landing gear foot plates and pull pins on both landing gear leg extensions. Once installed, the kit worked flawlessly. I placed red marker tape on the landing gear extensions so not to top out the legs when lifting. Again save all your old parts.
Cal
3/3/2022
After using the landing gear for over a year on several trips, the landing gear, motor, and gear box have Worked flawlessly.
Overall quality looks to be as good as the OE.Only problem was with the handling from UPS as box corner was torn and the cross bar was exposed (no damage) also the switch button was loose in the box (was able to snap back into place) I haven't installed it yet,but I'm sure it will be fine. Again thank you Etrailer and Joy for your quick delivery
Do you have a question about this Camper Jack?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Verified B.
6/9/2023
We have had no problems with the landing gear. After having it installed by someone it has worked perfectly ever since.