Plunger Diameter and Fitting Size of Uni-Servo Wheel Cylinder for Titan Brake Assemblies T0977700
Updated 07/21/2017 | Published 07/19/2017
Question:
What is the cylinder bore size? What is the thread size for hydraulic connection? Flare fitting? 3/16 brake line?
asked by: Marvin
Helpful Expert Reply:
I have some measurements of Uni-Servo Wheel Cylinder for 10", 12" and 13" Titan Brake Assemblies - Zinc - LH Item # T0977700 for you. The plunger inside has a 1.12 inch outer diameter. The rubber parts fit over a 1.5 inch diameter. And the center hole has a 0.25 inch diameter. I included some pictures showing the measurements.
The wheel cylinder does have standard fittings 3/16" with a thread size of 3/8"-24.
Product Page this Question was Asked From
Uni-Servo Wheel Cylinder for 10", 12" and 13" Dexter Brake Assemblies - Zinc - LH
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- Wheel Cylinder
- 10 Inch
- 12 Inch
- 13 Inch
- Uni-Servo
- Dexter
more information >
Continue Researching
- Shop: Uni-Servo Wheel Cylinder for 10", 12" and 13" Dexter Brake Assemblies - Zinc - LH
- Q&A: Recommended Replacement Brake Assemblies For Eagle Trailer Drum Brakes
- Q&A: Replacement Wheel Cylinders for 12 Inch Hydraulic Brakes on a 2000 Fastload Boat Trailer
- Q&A: Determining Capacity of Unknown Axle
- Q&A: 13-Inch Drums And Hydraulic Brakes For Farm Grain Wagon
- Q&A: Common Torque Specifications for Lug Nut Size
- Q&A: Replacement Grease Seal for Timken 171255
- Q&A: How to Pick Out Replacement Wheel Cylinders and Master Cylinder for Surge Brake Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)