Diameter Of Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks
Updated 01/10/2017 | Published 01/09/2017
Products Featured in This Question
Question:
Hi. I a am building an adjustable height outfeed table for some garage equipment. I am planning to use jack Code: TJD-7000S, but before I commit, I need to know the diameter of the crank handle. Can you please let me know? Thank you.
asked by: Steve S
0
Expert Reply:
I went to the warehouse and took a measurement of the Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks, part # TJD-7000S-HD.
The handle diameter is 1/2-inch. I have attached a photo of the handle with the dimension shown you can check out.
expert reply by:
Jeffrey L
0
click to enlarge
Product Page this Question was Asked From
Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks - 3K - 7K
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Continue Researching
- Shop: Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks - 3K - 7K
- Search Results: jack handle
- Video: etrailer and Ram Swivel Marine Jacks Rebuild
- Shop: Replacement Sidewind Handle for etrailer and Ram 2,000-lb A-Frame Jacks
- Shop: Aluminum Lynx Trailer Wheel - 17-1/2" x 6-3/4" Rim - 8 on 6-1/2 - Silver
- Q&A: Dimension From Pin Hole To End Of Shaft On Replacement Sidewind Handle # TJD-7000S-HD
- Q&A: Does the Replacement Sidewind Handle TJD-7000S-HD Have a 1/2" Diameter
- Search Results: fulton magnum series jack
- Search Results: trailer jack
- Q&A: Handle Diameter and Length to Fit etrailer.com Sidewind Jack Handle with Haul Master Trailer Jack
- Search Results: plug
- Search Results: trailer breakaway kit
- Search Results: 7 way plug
- Search Results: trailer plug
- Q&A: Are 800 lb and 1,500 lbs Replacement Fulton Trailer Jack Handles Interchangeable
- Shop: Replacement Sidewind Handle for etrailer and Ram Swivel Marine Jacks - 1,500 lbs
- Shop: Trailer Wiring
- Video: Hands-On with the Replacement Bearing for etrailer and Ram Square Jacks
- Q&A: Replacement Handle for Fulton Magnum Series Jack
- Shop: TowSmart Plug-In Trailer Connector Adapter w/ Wire Tester - 4-Way Flat to 7-Blade
- Shop: Replacement Sidewind Handle for etrailer and Ram Swivel Marine Jacks
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Video: Checking Out the Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Video: Bright Way Push-to-Test Trailer Breakaway Kit Review and Installation 3802308
- Q&A: etrailer Square Jack w/ Footplate to Replace Ram Side Wind Jack