Comparing Pop & Lock Manual Tailgate Locks PAL5500 and PAL5400

Question

Question:

Does the PAL5500 fit on a 2014 Tacoma the same way that PAL5400 does? Why is the 5400 more expensive that the 5500? Thanks for your help guys.

asked by: Mark M

0

Expert Reply:

Both of the Pop & Lock manual tailgate locks that you referenced, # PAL5500 and # PAL5400, are confirmed to fit your 2014 Toyota Tacoma's OEM tailgate. The difference between them is that part # PAL5400 is equipped with a lock cylinder that can be coded to match your ignition key, thanks to it including the patented BOLT coding technology.

expert reply by: Adam R

0

Answer 1

Yes! We've got exactly what you're looking for with the Replacement Lock Core for Pop & Lock Tailgate Lock #PL5400CONV. This replaces the existing lock core on your Pop & Lock Custom Locking Manual Tailgate Handle #PAL5500, which fits…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 9

There is a wiring kit for a brake controller Preston but it's not going to be a plug and play one. The 2025 Toyota Tacoma does not have a plug in brake controller port. Toyota stopped putting them in after the 2023 model. For your Tacoma, I…

view full answer...

Answer 10

I couldn't find an order with us so I'm not sure what you purchased before but etrailer hitch you're looking at, part #e98850, is custom designed to fit the Toyota Tacoma from 2005 through 2015. I'm also not sure where you're…

view full answer...

Answer 11

Hi Janet! I recommend the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" #e98850 for your customer's 2005 Toyota Tacoma. This will fit both the X-Runner and non X-Runner models, so it's the one to get.…

view full answer...

Comparing Pop & Lock Manual Tailgate Locks PAL5500 and PAL5400

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching