Will TorkLift Camper Tie Downs for a 2013 Toyota Tundra Require Drilling

Question

Question:

Hello guys, Please let me know if this is a bolt on system that can be done without drilling. My truck is a 2013 Tundra double cab 5.7 4wd, 8 FT BED, no step rails, factory hitch. THanks so much!

asked by: Jake C

0

Expert Reply:

The Torklift Tie-Down Kit part numbers # TLT2305 and # TLT3304 have been confirmed as a fit for your 2013 Toyota Tundra with an 8 foot bed, double cab, without running boards, and a with factory hitch.

Since these are a custom fit application there would not be any drilling involved either.

expert reply by: Jameson C

0

Answer 1

Unfortunately we do not have a video of the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 being installed. The Rear anchors are installed in the end of the bumper. There is no precise mounting location since a variety of bumpers may be installed.…

view full answer...

Answer 2

I have linked the instructions for the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 that fit your 2013 Toyota Tundra below. Be sure to get a set of HappiJac Original Turnbuckles #LC182898 as they are stainless steel and will last through the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

You sure do Mark. You actually need two sets of the Yakima item #Y00221 Landing Pads to mount crossbars in Yakima 60" HD Tracks like item #Y74MR. The landing pads are the attachment point for the crossbar towers so they're pretty important.…

view full answer...

Answer 6

Hey Mike, welcome back! Thanks for all of the info you listed from your Grand Design. Based on that and fact you have 5,200 lb axles the correct bearing kit would be the part #BK3-300 which comes with the correct bearings, races, seal, and a cotter…

view full answer...

Answer 7

Hey John, congrats on the new truck. Yes, the Brophy Slide In Camper Tie-Downs - Extra Clearance item #HSAB can be used with your 2026 Ram 3500 dually. What turnbuckles did you use previously with your 2021 Lance 865?

view full answer...

Answer 8

You can use the Brophy Clamp On Camper Tie-Downs #HSAB for your 2018 Ford F-350 Super Duty but we actually recommend going with the Camper Tie-Downs #HSSF instead as they have a slightly different design that better fits your Super Duty. Attached are…

view full answer...

Will TorkLift Camper Tie Downs for a 2013 Toyota Tundra Require Drilling

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching