Brake Controller Installation Kit Install for a 1998 Dodge Ram

Published 11/17/2015

Products Featured in This Question

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3397)

$121.19

Hook Probe Circuit Tester

(60)

$12.27

Question:

have 1998 dodge ram 1500 pickup have a 4-way wired in back was gonna put your 7+4way kit ETBC7 on with a trailer brake controller.. my pickup dont have factory plug in under dash anywhere.. would I splice into brake light switch in cab for brake pedal with red wire from brake controller??? thanks!

asked by: Gene

Expert Reply:

When wiring up the red wire of the brake controller you will need to find a circuit that only sees voltage when the brakes are applied and then none when released.

Typically this is found near the brake pedal. You would need to use a circuit tester like part # PTW2993 (or what comes with the # ETBC7) to find this circuit.

You can also use the third brake light circuit that runs to the top of the cab like you mentioned as well.

I attached a install video that shows the # ETBC7 being installed in a very similar 1999 Dodge Ram as yours.

expert reply by: Jameson C