See what our Experts say about this CURT Trailer Hitch

• The Best Trailer Hitch for a 2014 Mercedes Sprinter Van with Factory Step Bumper
  What you see in the pictures for Curt trailer hitch # 13358 is the factory step bumper that comes on some Sprinter vans. There is probably an aftermarket version of it out there but we do not carry it. It is attached separately from the vehicle on the underside. Take a look at the picture I have included that shows the different attachment points for the hitch and the step bumper. If you plan on installing one of these steps then you would need a hitch like # 13358 designed for models...
  view full answer...
  
• Can Tongue Weight Capacity Be Increased To Haul Motorcycle On a 2018 Mercedes Sprinter 2500 4x4
  The highest rated trailer hitch we have for a 2018 Mercedes-Benz Sprinter 2500 4x4 with 170" Wheelbase is the Curt Trailer Hitch Receiver part # 13358 if you have the factory step bumper which is rated for 5,000 lbs gross trailer weight and 500 lbs tongue weight or the Curt Trailer Hitch Receiver part # C13388 if you have the standard bumper which is rated for 6,000 lbs gross trailer weight and 600 lbs tongue weight. Unfortunately, there isn't any way to strengthen the tongue but the factory...
  view full answer...
  
• Are There Front Hitch or Recovery Accessories Available for my 2018 GMC Savana Van?
  I have a solution for you to add tow hooks to your 2018 GMC Savana Van, but there currently are not any front mounted hitches or winch capable bumpers available to fit your van. I recommend adding tow hooks similar to the Curt Bolt On Tow Hook with Keeper # C22411 to the frame of your Savana van to help with recovering your vehicle if you're ever caught in that position again. If you have a rear mounted hitch, you could also add the Curt Forged Tow Hook # C45500 to provide you with a...
  view full answer...
• Distance Between Brackets of Curt Hitch 13358 for 2018 Mercedes Sprinter 3500
  I can go ahead and give you the measurement between the bolt holes for the Curt Trailer Hitch Receiver # 13358. As you can see by the accompanying diagram, this hitch measures 39-1/2 inches between the brackets from inside to inside, and you can use that to determine if it will fit along with the ramp on your 2018 Mercedes-Benz Sprinter 3500. I have added a link below to the installation instructions for you to check out as well of the Curt Hitch # 13358.
  view full answer...
  
• Picking Out Hitch for 2023 Mercedes Sprinter High Roof
  Hey Mike, to pick out the correct hitch for your 2023 Mercedes Sprinter 2500 high roof comes down to what style of rear bumper your vehicle has. If it's a standard bumper the Curt part # C13388 is a really great option. If it has a factory step bumper instead you'd want the part # 13358. Curt makes really high quality hitches so going with a Curt will be your best option.
  view full answer...
• Is There a Trailer Hitch Receiver Available For a 2023 Mercedes Sprinter 1500 With Bumper Step?
  I currently do not see a trailer hitch receiver for your 2023 Mercedes Sprinter 1500 with a bumper step. This would require you to have a custom receiver fabricated using the Curt Weld-On # E17. The Curt Receiver # 13358 you found will only fit on the 2500 and 3500 models.
  view full answer...
• Recommended Trailer Hitch for a 2018 Coachmen Prism On a Sprinter Chassis
  Ric, yes the Curt Trailer Hitch Receiver # 13358 will work great with your 2018 Coachman Prism on a 2015 Mercedes-Benz Sprinter chassis. This hitch has a GTW capacity of 5,000 lbs so it's still going to be a bit underrated to tow your Jeep Cherokee Trailhawk. Since your Jeep is so heavy, I'd actually recommend stopping by a hitch shop and have your Sprinter outfitted with a custom reinforced hitch that can handle your Jeep.
  view full answer...
• What is the Best Hitch for a 2023 Mercedes-Benz Sprinter 2500 w/ Factory Step Bumper?
  Thanks for the pictures! The best hitch for your 2023 Mercedes-Benz Sprinter 2500 is the etrailer item # e82TR. This hitch is custom fit and bolts to your Mercedes with included hardware. This is a class III hitch with a 2" receiver. It has a 5,000 lbs towing capacity and a 500 lbs maximum tongue weight that can be increased to 7,500 lbs and 750 lbs when used with a weight distribution system. The reason the etrailer item # e82TR is the best hitch is because of its ease of installation...
  view full answer...
  
• Difference Between Curt & etrailer Trailer Hitches For 2024 Mercedes Sprinter 2500 w/ Step Bumper
  Just a single difference exists between the Curt and etrailer trailer hitches for your 2024 Mercedes Sprinter 2500 with a factory step bumper, which is the finish. The etrailer hitch has a matte black finish, while the Curt hitch has a glossy black finish, so you can choose which you prefer. The hitches that fit your Sprinter are the following part numbers: - Curt Trailer Hitch Receiver # 13358 - etrailer Trailer Hitch Receiver # e82TR The matte black finish does hide those inevitable...
  view full answer...
• Will Installation of a Hitch Interfere w/ the Parking Sensors on 2022 Mercedes Sprinter 2500?
  Yes, the Curt Trailer Hitch Receiver item # 13358 does fit the 2022 Mercedes-Benz Sprinter 2500 with the factory step bumper. This hitch is custom fit and bolts to your Mercedes with included hardware. We have not heard of any issues with the rear sensors on a 2022 Mercedes Sprinter when using the Curt Hitch item # 13358. We have installed this hitch on several similar vans and have not had any problems so you will be good to go. I have attached a couple of pictures below that shows how...
  view full answer...
  
• Trailer Hitch that Fits 2017 Mercedes Benz Sprinter 2500 with Factory Step Exhaust
  We have the Curt hitch part # 13358 which is a confirmed fit for your 2017 Mercedes Benz Sprinter 2500 with a factory step. If you check out the attached picture you can see how it fits with the factory exhaust setup.
  view full answer...
  
• Trailer Hitch Recommendation for 2016 Mercedes Benz Sprinter 2500 with Step Bumper
  We do have a trailer hitch fit for your 2016 Mercedes Benz Sprinter 2500 that has the factory step bumper. The Curt hitch part # 13358 would be what you need. This fits either length wheelbase as well. In the picture I attached you can see the hitch fitting below the step bumper. I also attached an install video for you to check out too.
  view full answer...
  
• Is Curt Hitch 13358 Going to Be Too Recessed When Installed on 2019 Mercedes Sprinter 2500
  The Curt hitch part # 13358 is recessed under the step bumper like you can see in the attached picture but it's not recessed to the point it wouldn't work well. It wouldn't interfere with the camera setup either.
  view full answer...
  
• Hitch and Wiring Harness for a 2022 Toyota Tacoma SR
  For a complete towing set up for a 2022 Toyota Tacoma you're going to want to start with the Curt Trailer Hitch Receiver item # C13264 you were looking at. This hitch is custom fit and bolts directly to your Tacoma with included hardware. It is the best hitch capacity hitch for your truck. You will also need the Tekonsha OEM Replacement Vehicle Wiring Harness w Brake Controller Adapter item # 22117. This custom-fit T-One connector plugs into your Tacoma's wiring harness, which is located...
  view full answer...
• Will Curt Trailer Hitch for 2016 Mercedes Sprinter 2500 13358 Allow Spare Wheel Carrier to Fit
  The Curt hitch part # 13358 that you referenced fits the long and short wheelbase versions of your 2016 Mercedes Benz Sprinter 2500 with the factory step bumper. To determine if your spare carrier will fit past the bumper when this hitch is installed you'd need to take one measurement. You'll need to measure from the hitch pin hole out to the nearest upright portion of the carrier. If that distance is greater than 6-1/2 inches it will fit in this hitch and clear the rear bumper.
  view full answer...
  
• Recommended Trailer Hitch Between Curt 13358 And The Draw-Tite 75601 Mercedes-Benz Sprinter 2500
  Both the Curt hitch # 13358 and Draw-Tite hitch # 75601 will fit your 2016 Mercedes Sprinter 2500 if you have the 170 inch wheel base and factory step bumper. Its almost a dead heat between the two, but I'm giving the edge to # 13358. The # 13358 has more positive reviews about this product and it is made is the USA. It also step-by-step install videos for you to watch on an earlier model of the Mercedes-Benz Sprinter. Both hitches are Class III hitches with 2 inch receivers and they...
  view full answer...
• Recommend Hitch for a 2021 Mercedes-Benz Sprinter 2500 Van
  I would be happy to help you find a hitch receiver for your 2021 Mercedes-Benz Sprinter 2500 van with a factory step. In order to haul a trailer you are going to need a wiring harness as well. The Curt item # 13358 you were looking at is the best hitch receiver available. I highly recommend it based on its ease of installation, weight capacity, and the built in bracket for attaching a wiring harness. The Curt Trailer Hitch item # 13358 has a maximum gross trailer weight of 5,000 lbs and...
  view full answer...
  
• Dimensions Of Curt Trailer Hitch Receiver # 13358 For a 2020 Mercedes Sprinter 3500
  The Curt Trailer Hitch Receiver # C13388 will not fit your 2020 Mercedes Sprinter 3500XD with the 170" wheel base. I measured the receiver in our shop and it 33-1/2" wide between the frame rail mounting points. We do also have the Curt Trailer Hitch Receiver # 13358 that mounts to the outside of the frame. While Curt has not been able to confirm that this will fit on an XD version of the Sprinter 3500 you can check your frame outside width to see if it has the same width. This receiver...
  view full answer...
  
• Trailer Hitch For A 2019 Mercedes Sprinter 2500 with Factory Step Bumper
  For your Sprinter 2500, I recommend the Curt Trailer Hitch Receiver # 13358 that will do a great job for your bike carrier and more should you decide to tow later. This hitch model is designed for either the 144" or 170" wheelbase Sprinter vans with the factory step bumper and is a confirmed fit. I recommend the Kuat NV 2.0 Base 4-Bike Platform Rack # BA22B-BA02B as a solid option to carry your 4 bikes for an outing. The ratcheting hooks and straps mount the bikes by the tire so there...
  view full answer...
• Is Class IV Trailer Hitch Available for a 2023 Mercedes-Benz Sprinter 2500
  There are only Class III hitches that will fit your 2023 Mercedes-Benz Sprinter 2500, and out of our selection I recommend the Curt: - Curt Trailer Hitch Receiver # 13358 According to my research your Sprinter is only able to tow up to a 5,000 lb trailer so anything more than a Class III would be rated for well over that.
  view full answer...
• Exhaust Making Contact with Trailer Hitch on a 2016 Mercedes Sprinter 2500
  You will not need to cut the exhaust tip on your 2016 Mercedes Sprinter 2500. There are some ways that you can adjust the exhaust to correct the issue so there is clearance between it and the hitch. I have included a link to our help article that covers this topic. The fix could as easy as bending an exhaust hanger a little or, worse case scenario, a muffler shop could make adjustments. But cutting the exhaust is not something that you would have to do.
  view full answer...
• Van build and Recommended Receiver Hitch for 2021 Mercedes-Benz Sprinter 2500
  If your 2021 Mercedes-Benz Sprinter 2500 has the factory step bumper, I suggest the Curt Trailer Hitch Receiver, # 13358. If you have the standard bumper, then the Curt Trailer Hitch Receiver, # C13388. Both of these are Class III hitches that are fully welded in their construction and have received an excellent powder coated finish. They are a bolt-on installation and each will fit the long or short wheel base version, type bumper that is in place is the deciding factor for over the...
  view full answer...
  
• Does Trailer Hitch Install on 2014 Mercedes Sprinter Require Step Bumper Removal
  There aren't any trailer hitches that fit your 2014 Mercedes Sprinter with the factory step bumper that would require the removal of the step bumper to install. When we installed this hitch on a 2014 Sprinter just like yours we found that from the top of the hitch opening down to the ground measured 17 inches. I attached the install video of this hitch on 2014 Sprinter just like yours.
  view full answer...
• 2017 Mercedes Sprinter 2500 144WB w/ Factory Step Bumper Hitch For Ground Clearance
  The Draw Tite # 75601 and the Curt # 13358 that you referenced both are a fit for your 2017 Mercedes Benz Sprinter 2500. They have very similar ground clearance but the Curt has the slight edge as it seems to sit a bit higher. I attached a picture that shows the difference. The Curt is in the top picture.
  view full answer...
  

Do you have a question about this Trailer Hitch?