Discover Lippert - Parts & Accessories for Your Journey

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

Hey Pete, thanks for the picture and information. Since the Thetford 42070 is an Aqua-Magic Style II toilet, the Replacement Water Valve item #TH78SA will indeed fit it. This kit will replace the valve and the seals around it.

Hello Greg, thanks for reaching out. You are on the right track looking at the 21' fabric and roller kits. The Replacement Roller and Fabric Kit for 21' Solera Power and Hybrid RV Awnings #LCV000211532 you were looking at does not have a…

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

Yes, we do offer replacement jacks for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System - 6-Point Set part #LC675817. I have attached these for you below by their location on the trailer. Rear/Middle: 24-1/2" Leg part…

Based on the pictures you definitely need the awning support arm #LC281154. I can't tell in that other photo if the pin is bent or damaged, or just barely hanging in there. I'm also not sure if your idler head and roller endcap are ok or not…

Great question, Matt, and you’ll be glad to know: no programming or special setup needed for the Electric Brake Assembly 12" ABS #LC83PX. These brake assemblies work just like standard electric brakes on your trailer’s wiring. One wire goes to…

In order to test the controller on the Lippert Ground Control 3.0 Electric Leveling System you'll first need to obtain a multimeter. Once you have this then you will need to use the ground probe and place that on the green wire coming from the…

Hello Gary, thanks for providing all of the info and part numbers for your awning. That does come back as one of the Lippert 2000 series awnings. It sounds like you might be looking for the Replacement Pitch Arm Assembly #LC93BX which is for the 2000…

The Regal Drive Head #LC53TF is a little skinnier and doesn't have a logo while the Plain Drive Head #LC273478 is a little wider and has the LCI logo on it (see attached).