Bright Way

Hi Walter, For the Deka Battery Isolator #DW08770 you can go with 8 gauge wire. Deka actually makes an installation kit with this wire, the Deka Battery Isolator Installation Kit for Standard Alternators #DW08769.

The lid of the Bright Way Trailer Breakaway ICU Kit with 12V, 5-Amp-Hour Battery, Charger, and Wire Loom #BW94FR that you referenced has a wiring diagram shown that details how it wires. Not seen is there is a single wire that runs up to running…

Since you've already got a 4 pole on your trailer, you'd just need to add a 7-way with #ETBC7 so that you can run a charge line using #10-1-1 from the accessory circuit to your battery. This circuit is located at the 1'oclock…

Yes, the Dexter Electric Trailer Brakes #23-180-181 will indeed be compatible with the Easy Grease Trailer Hub and Drum Assembly #AKHD-655-6-EZ-K. The brake assemblies use the standard 12" x 2" brake shoes, and the hubs are designed…

The replacement pin and cable you need for your Bright Way breakaway switch part #3802348 is the part #3802350!

A diode like the part #RM-690 is a great idea but the only issue is that is has a max load of 85 amps. A standard 5,000 lb winch, like the ComeUp DV-5000si #CU645010, will greatly exceed the 85 amp rating of the diode so it would be useless. What…

Thank you for your purchase of the Electric Trailer Brake Kit w/ Dust Shields part #AKEBRK-10. In some cases, you can remove the spindle nut with a set of channel locks but in others you will need to use a socket and ratchet or even possible a…

If I'm understanding you correctly the starter solenoid #PK5231201 is not the solution to your problem. Based on what you have described, it sounds like both the breakaway battery and winch battery are hooked to the 12V power coming from…

The Dexter DX Series #K71-651 and the Hydrastar Vented Marine #HS381-8067 are more comparable as they both have hardwire installations (just made by different manufacturers) while the Dexter BrakeRite II #T4813102 is more of a…

The Bright Way Solar Battery Charger #BRW54FR is what you are looking for to connect to the Bright Way Push-to-Test Trailer Breakaway Kit #3802308. The solar panel will help to maintain battery power when not used for long periods of time. It has…

The battery you use for a break away system needs to be able to power the trailer brakes on full for 15 minutes. A 12 volt battery rated for 5 amp hours is normally used, unless you have 3 axles each with brakes, then you would benefit more from a…

12k trailer brake assemblies like the part #23-442-443 and 15 assemblies like part #23-446-447 can both be 12-1/4 inch by 5 inch and use the same 7 bolt mounting pattern so dimensionally it's hard to say. I would look for part numbers on…