Detailed Breakdown of the Replacement Idler Head Pin for Solera RV Awnings Video

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

Since you were looking at the Regal style idler head #LC672052 I'm assuming you need to replace the idler head pin on your Solera awning. You can remove the old pin and install #LC27WD for a replacement. If by key you mean a cotter pin, then yes…

Hello Jon, I wish I had some instructions to send your way, but Lippert doesn't make the instructions for replacing this part. I would like to mention that working on Awnings can be pretty dangerous due to the tension, kind of like a garage door.…

Hello Mike, thanks for reaching out. The best way to differentiate between the plain and regal style awnings is by looking at the drive head. The regal drive head is a little skinner and doesn't have a logo on it. The plain drive head has a LCI…

Hey Joseph, yes you can but you will need to swap out the lower vent assembly with the part #LC44DX which was designed for non-ducted applications like what you have. Did you have chance to use the kit in a ducted application?

Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…

In order to remove the old retaining pin from the drive pin on your Solera awning you will first need to remove the cover. The Drive Head Retaining Clip #LC266137 slides into the groove on the Drive Head Pin for Solera Power RV Awnings #LC266141. You…

It appears the wiring to connect a Trailer Brake Controller #90195 on your 2024 GMC Yukon are going to be high up on your dash close to the left side of the drivers compartment. You can start by removing the left side panel of the dash which sits up…

Thank you for the picture, I can see the pin is bent rendering your solera head shaft inoperable even though you tried bending it back. Unfortunately, the only fix would be to completely replace the head as this part isn't currently available…

The Regal Drive Head #LC53TF is a little skinnier and doesn't have a logo while the Plain Drive Head #LC273478 is a little wider and has the LCI logo on it (see attached).

An alternative version to the Replacement Drive Head Pin for Solera Power RV Awnings #LC93FR (Regal Style) is the part #LC266141 which is for the Plain Style. This has a flattened end on both ends of the pin which sounds like what you're looking…