Wiring Diagrams for Installing Bright Way Trailer Breakaway ICU Kit # BW94FR

Question

Question:

How do u wire it completely

asked by: Dwayne M

0

Expert Reply:

The lid of the Bright Way Trailer Breakaway ICU Kit with 12V, 5-Amp-Hour Battery, Charger, and Wire Loom # BW94FR that you referenced has a wiring diagram shown that details how it wires. Not seen is there is a single wire that runs up to running light circuit for the alarm. This a standard style of breakaway kit that would install like any other similar option.

I also attached a second picture that shows a more detailed wiring diagram plus a review video for the kit and a link to a help article on installing kits like this as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Replacing the passenger tires you have on your trailer as soon as you can is a smart idea as passenger vehicle tires are not rated properly for trailer use and they would be very likely to fail. In the tire size of ST225/75R15 the best option is the…

view full answer...

Answer 2

I have added an image below for the Bright Way Push-to-Test ICU Trailer Breakaway Kit #BW94FR as well as an installation video that is also very helpful. Here is where all the wires will connect from both the battery box and the breakaway switch.…

view full answer...

Answer 3

The alarm on the Bright Way #BW94FR is designed to go off whenever the trailer is disconnected. So as soon as it no longer senses power from the 7 way plug on your truck, it will activate the alarm. It sounds like the 7 way plug on your truck only…

view full answer...

Answer 4

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

view full answer...

Answer 5

The two wires that come from the breakaway switch #3802348 need to be connected to power and the brake signal switch. The black wire needs to have power. Once you have that connection made you then can locate your brake signal wire from your brakes…

view full answer...

Answer 6

Wiring connections for the Electric Over Hydraulic Brake Actuator are as follows. Yellow - Cold side of breakaway switch, The wire that goes hot when a breakaway occurs. Black - Positive connection on breakaway switch, The wire that charges the…

view full answer...

Answer 7

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 8

The interior lights of your enclosed trailer are likely connected to the 12V (Auxiliary) power pin on the 7-Way of your trailer. You can verify this by applying 12V power from a separate battery to this pin and seeing if that supplies power to your…

view full answer...

Answer 9

EZ Lube axles like the item #T3584F-EZ-8974 come from the factory with just a little bit of grease in the bearings. The first time you use the EZ Lube feature to fill the axle, it will take a lot of grease. You will probably use 3/4 to a full tube…

view full answer...

Answer 10

If the charge light of the breakaway system part #PS50-85-320 is staying on the charging state that means that box is drawing power to some extent. Although your battery seems like it's fully charged the 12 volt power circuit is still able to…

view full answer...

Answer 11

The Black wire coming from the breakaway switch would run to your junction box and connect to your brake wire terminal (this should be blue or black). The blue wire coming from the switch would go to the blue wire on the battery box. As far as…

view full answer...

Answer 12

For your 3,500lb Dexter Torsion Axles you would most likely need the Torflex Lift Kit - Single Axle - 2-5/8" Lift #K71-707-01. You will first need to verify that your torsion axles are not top-mounted and that you do not have 3" high…

view full answer...

Wiring Diagrams for Installing Bright Way Trailer Breakaway ICU Kit # BW94FR

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching