2014 Scion FR-S 2.0L H4 Engine Exhaust

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

Hey Paul, it looks like the OEM springs of your 2021 Ram 2500 are rated for 2,218 lbs per spring whereas the SumoSprings part #SSC-52 are rated for 2,475 lbs.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hey Tim, thanks for reaching out! If you're replacing a GE AC unit, then the GE Appliances Deluxe Plus RV AC #GE64FR will work with your thermostat, but if you're replacing a different brand of AC with this GE, then we'll need to get you…

Hello Jim, Wow, they quoted you seven hours for a trailer hitch install? That seems really high. The EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2" #EH87CR is specifically designed for the Hybrid version of the 2025 Toyota…

Hey Jack! First of all, congrats and the soon to be new travel trailer! Ideally the correct WDS is going to put your trailer's tongue weight right around the middle. It looks like your trailer comes in at 9,630 lbs, so if we figure 15% of that…

Hey Chris, Our Fitguide can be a bit confusing sometimes. Essentially the whole category is broken down into whether they fit diesel or non-diesel models. Since the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR fits both gas and diesel…

Hello Dan, thanks for reaching out. The Firestone #F2550 for the 1999 Ford F-250 2WD will be compatible with the B&W Turnoverball gooseneck hitch. The brackets are designed specifically to be compatible with in-bed hitches like the B&W, so if…

The inner diameter of the expanded ends of the part #CAM44812 is 1.53 inches and the outer diameter of the non expanded end is 1.51 inches. So basically this setup is designed to either slip into a 1-1/2 inch pipe or slip over a 1-1/2 inch pipe.

For an application where steeper inclines will be traveled on the Invisi-Brake #RM-8700 would not be my first choice for a supplemental braking system since the braking pressure when you apply the tow vehicle's brakes will always be the same…

Hello Phillip, thanks for reaching out. Yes, the Reese Dual Cam #RP26002 WD system can be used with a Reese Friction Sway Control #83660. As long as the head of your WD hitch has the pre-welded tab for the sway control ball (pictured below), the…