We certainly have a large selection of electric trailer winches and everything else you would need to launch and retrieve your boat but I am a bit confused on how you are trying to accomplish this. Would it be possible for you to sketch a quick…
Hello Tom, thanks for reaching out. Yes, you can use the Bulldog Winch Mount #BDW20353 along with a Roadmaster base plate on your 2019 Wrangler Rubicon which is part #RM-521453-5. The picture below shows an example of a similar winch mount installed…
Since you are wanting the most rust proof E-Track I recommend the etrailer Horizontal E-Track - Galvanized Steel - 2,000 lbs - 4' Long #e95VR as its galvanized finish will be the best for rust prevention, and will hold up fine even though you…
Hello Amadeo. I just spoke with my contact at Yakima regarding your question. The OffGrid Cargo Basket #Y07138 does not come with T-slot mounting hardware, so I am not sure exactly what hardware you are using currently. That said, if you need to be…
The manufacturer does not provide a weight rating for the Erickson E-Chock Wheel Chock for E-Track, #EM09162. These are designed with overall dimensions of 8-1/2" long x 6-3/8" wide x 4-1/2" tall and to be used with a tie-down strap.…
I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…
Hello Michael, thanks for reaching out. The Roadmaster Dual Hitch Receiver Adapters #RM23SR and #RM-077-10 both have 10" between both receivers and they are both rated or 10,000 lbs. The only noteworthy difference is the placement of the…
The Swagman Dispatch 2 Bike Platform Rack - 2" Hitches - Frame Mount #S44FR will be about 33 inches from the hitch pin hole to the farthest point of the rack. You will need to measure your tow bar to see how much actual clearance that will give…
The Roadmaster Dual Hitch Receiver Adapters like part #RM-077-10 or any of the other adapters I have attached for you in the link below can be flipped so that raised receiver tube is on the bottom with the tow bar or so that the raised receiver tube…
Some trucks do need an under-the-hood connection of wiring to activate the 12V trailer power feed and the trailer brake controller power input feed. This process is outlined and illustrated in the linked article, in the section titled…
That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
I spoke to Demco, and unfortunately the Coupler #DM15349-52 cannot be mounted to the bottom of a frame. They went on to say that there would not be enough surface area for it to handle the weight when welded or bolted on. That being said, the Ram…
Filters
