Thanks for reaching out, Nick! I'm not 100% sure what your bolt pattern is so I'll include a few different options. Some of the numbers you gave are OEM number so based off that I THINK your bolt pattern is a 5 on 4-1/2. You will want to…
Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
Janice, a single #MB34FR plug-in covers about 400 sq. ft., which is enough for one section of your Montana. Because sound waves don’t pass through walls and cabinets, many RV owners install two units - one up front near the bedroom and another in the…
Yes, it is Luke. The MouseBlocker 360x Electronic Rodent Deterrent - 110V AC item #MB64FR has two ultrasonic wave types that alternate continuously. Do you already have a rodent problem or are you just trying to avoid one?
Hey Joe, welcome back! I'm not entirely sure where our 15" measurement came from but you will be able to add your 13" diameter tank to the inside of the #3371701385. The front to back measurement is 16.16" and then the lip will…
Hello Brett, thanks for reaching out. For you I recommend the InfiniteRule Coupler Lock #IR66FR. This lock is made specifically for the Demco EZ-Latch couplers, and it will work with both the 2" and 2-5/16" ball couplers. It has a 42,000 lb…
Hi Rod, There is not a plug-in wiring harness for a 2008 Chevy Silverado 2500 for the Tekonsha Prodigy P3 Trailer Brake Controller #90195. The wires are already run under the dash, and I have added a link below to a video which shows the install.
I was able to verify that the weight capacity for the Aluminum Car Hauler Ramp Set #288-07503 that you referenced is indeed 6,000 pounds (not kilograms) for the pair and 3,000 pounds per panel. The recommended maximum height of 16 inches is simply…
I went ahead and reached out to RAM and they explained to me that to re-install your inner leg to your RAM jack like the Square Direct Weld Jack - Drop Leg w/ Spring Return #TJD-12000SP-R2NH, you are going to need to re-install the lower pin, replace…
The InfiniteRule Lock for Demco eZ-Latch #IR66FR will fit 2" and 2-5/16" couplers. This lock has an internal length of 2-15/16" to fit the pin hole on your coupler. I have linked an image below showing it on a 2-5/16" coupler in…
Yes, the Draw-Tite #24979 is a confirmed fit on your 2020 Volkswagen Golf GTI and it will do a good job for you to carry a bike rack. For installation you would likely want to use either an autobody or mechanic's shop, or preferably an RV dealer…
Filters
Tarps Parts or Accessories
