Filter by Location

$4.16 - $15.41

$10.96 - $10.96
Videos
for RV Cabinet and Drawer Hardware
Help Articles
for RV Cabinet and Drawer Hardware
Expert Answers
for RV Cabinet and Drawer Hardware
Hey Clyde! The Furrion Chill Cube will be a really nice upgrade so I highly recommend going that route for replacement. This unit is super quiet and incredibly efficient with a lot of cooling power. This will be a complete replacement since…
view full answer...Hi Ron, welcome back! The Replacement Signal Booster #VAL29RB is compatible with your TM-77. In addition to the listed A1AS, i10, and Smart TPMS it works with the TM66 and TM-77. What happened to your old signal booster?
view full answer...Hello Tyler, Wow, that is quite the nice set-up you have! Happy to get those measurements to you so you can see which will work best for you. The PullRite SuperGlide 5th Wheel Hitch for Ram Factory Prep Package - 24K #PUL28RR has a fixed height of 16…
view full answer...Hello Darrin, Sorry to hear that your Dometic Penguin went into retirement. The RV AC's went to a new refrigerant this year, they went from the R410a to the R32. You cannot mix the old R410a parts with the new R32 parts, they have made them to…
view full answer...Hey Chris! The TowSmart Trailer Hitch item #TS75ZR is confirmed to fit the 2019 Ram ProMaster 3500. This is a class III hitch with a 2" receiver. To add a 7-way and 4-way connector to your van you'll need two separate wiring harnesses. The…
view full answer...Hey welcome back, Jody. So your best option here will be to get a new 50 amp surge protector for your new travel trailer. If you did end up at a camp ground with 50 amp service you would want to have it. I know a lot of sites do have just 30 amp but…
view full answer...We do have a lift kit for your Lippert 7K torsion axle but the Dexter Torflex Lift Kits like part #K71-725-02 are designed to fit specific Dexter torsion axles. For example, the above mentioned kit will only fit a #12 Torflex axle that has a 5,500 -…
view full answer...Hey Steve, thanks for reaching out! The Roadmaster Direct-Connect Base Plate Kit #RM87NQ fits your 2025 Ford Maverick as long as it's the Hybrid model that doesn't have the engine block heater. It doesn't come with the 6-Pin connector,…
view full answer...Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…
view full answer...Hey Peter, thanks for reaching out! The SeeLeveL Sensor for RV Holding Tank Monitor #SE78VR is designed to adhere to a plastic tank, since most RV tanks are plastic. If you want to add more of a durable hold to the sensors, then SeeLeveL recommends…
view full answer...Hey Alan, yes you can use the Active Controls ActiveStart Plug-In Soft Start for RVs #AS44FR with a surge protector. You would want it to go surge protector, soft start, and then to your camper so that the soft start also has surge protection…
view full answer...If your LED Trailer Tail Light w/ Reflector - Weatherproof - 4 Function - 76 Diodes - Clear/Red Lens Item #DG52721PB on your 2018 Ford E-Series Cutaway is getting moisture in the reverse light then it is most likely not properly sealed. Allow the…
view full answer...Filter Results
Cabinet Hardware
$4.16 - $15.41
Drawer Hardware
$10.96 - $10.96