Filter Results
$33.64 - $33.64
$18.99 - $397.97
$57.60 - $57.60
Videos
for Boat Bumpers
Help Articles
for Boat Bumpers
Expert Answers
for Boat Bumpers
Thank you for all of the photos and information! From what I can see it looks like you have a #84 spindle but that inner bearing blew out so you should be able to remove that inner sleeve that looks like it's still on the spindle (next…
view full answer...The Westin Custom Fit Truck Bed Mat #50-6405 will fit perfectly in your 2022 Ford F-250 Super Duty Short Bed and you won't need to trim anything! Just be mindful that these come rolled up in a box so you'll need to unroll it…
view full answer...The Kenda 4.80-12 Bias Trailer Tire with 12" Galvanized Wheel - 5 on 4-1/2 - Load Range B #AM30590 have a max speed of 65 mph. When trailer tires are not speed rated with a letter, the default is 65 mph max. I've attached an…
view full answer...Having 2 wheels will provide more surface area/contact with the ground. This could actually make it more difficult to maneuver compared to a single wheel. But two wheels are better than one when not on pavement. A single wheel tends to dig into…
view full answer...It is recommended to cover all of the exposed wood. When the wood is exposed there is a greater risk of rot and damage. The carpeting is made of breathable polyester which makes sure it can dry out so no mold will build up and damage the wood or…
view full answer...The rails of the RetraxPRO MX Hard Tonneau Cover #RE57FR are going to block the stake pocket a bit so you'd most likely have to notch the rails as well if you wanted to keep the sports bar. This is a super common issue and what typically ends…
view full answer...Since your Kwikee 32 series step was made before 1999 you'll need the upgrade kit part #LC379145 to replace the motor and other components needed. This comes with more than just the motor but the motor design has since changed so the…
view full answer...The #CE10002G-4 CE Smith Bolster and Swivel is 13" tall. Assuming you mount it at the position to gain the most height, you should have 9" remaining. Losing the height from attaching to the 3" crossmember leaves you with…
view full answer...I went out to the warehouse and pulled a CE Smith U-Bolt, part #CE15252A and took some measurements for you. The threaded portion is 2-1/16". The outside width is 4". The outside length is 3-1/8". Check out the photo of the…
view full answer...For a u-bolt that will fit a 3" wide x 1-1/2" tall trailer frame you can use the CE Smith U-Bolt part #CE15252A which is 3" long x 3-1/8" wide x 7/16" diameter. Please note, the u-bolt width must be wider…
view full answer...It is always a good idea to use a winch that is overrated for the purpose you will be using it for. A winch that is used near the bottom end of its capacity will last much longer then a winch used at the top end of its capacity. We do have wire…
view full answer...Yes, the Taylor Made Personal Watercraft Fender #3691069 does fit your Kawasaki Jetski Ultra 310 SE.
view full answer...