Video Transcript for Detailed Breakdown of the Kodiak 13" Rotor

Speaker 1: Today we're going to take a look at the Kodiak 13" Dacromet finish rotor with the 8 on 6-1/2" bolt pattern for 7,000 lb axles. Now this is a slip on over the hub rotor. Makes it very easy to convert your idler axle to a disc brake axle. It's designed to fit over a standard idler hub and it's held in place by the wheel and wheel bolts. It is a cast iron construction, which ensures a favorable friction coefficient for necessary stopping power. This rotor here has a Dacromet plating to it, which provided superior corrosion resistance for fresh water or salt water use.

It has a $300 to $400 salt spray rating. If you notice on the rotor it's a vented design, which will effectively dissipate the heat, prevents any heat related damages. And what's nice about the slip on rotors, there's no need to replace your entire hub and rotor assembly if only the hub or the rotor becomes damaged.Now the distance from hub face to hub face will increase by approximately 1/2". This part is made in the U.S.A. A few specs on it again, this is designed for axle capacity of 7,000 lbs.

The wheel size that will work on this is 16" and larger. The bolt pattern is an 8 on 6-1/2" bolt pattern. Outer diameter on this rotor from edge to edge is 13". The inner diameter portion, which is measured inside to inside here is 9" and the bold hold diameter is 1/2". But that should do it on the review on the Kodiak 13" Dacromet finish rotor with the 8 on 6-1/2" bolt pattern for 7,000 lb axles..