Customers prefer these similar products
Safe for carbon frames and strong enough to carry your heavy bikes, this hitch bike rack will handle road bikes, mountain bikes, and anything in between. Ratcheting hooks and wheel straps hold your bikes by their wheels with no frame contact.
Features:
Specs:
Note: May interfere with bikes with front fenders.
The Yakima HoldUp is a premium, tray-style bike rack that lets you carry 2 bikes using your vehicle's hitch. This rack is specifically designed to carry bikes with big tires and wide handlebars, but it will carry just about any bike, including those with wheels from 20" to 29", carbon frames, disc brakes, thru axles, or full suspensions.
The HoldUp is easy to load, even if your bikes have monster wheels. The deep, contoured front wheel cradles accommodate just about any wheel out there, and the pivoting arms with StrongArm technology ensure that your bikes are held firmly in place.
Note: Not recommended for use on bikes with front fenders.
To load a bike, simply place your front wheel in the holder, rotate the pivoting arm up and over the wheel, and press down firmly on the ratcheting hook. To release the hook, simply press the built-in red button and slide the hook up and off your wheel.
Large rear wheel holders allow the HoldUp to accommodate a wide variety of bike wheelbases. These wheel holders pivot front to back, adjusting automatically to your wheel size - no need for sliding and tightening. Secure the wheels in place with the ratcheting straps built into each holder.
Mounting bikes by the wheels helps prevent any scratches or scuffs to the paint. The ratcheting hooks are padded, however, so they won't mark your wheels. And the pivot mechanisms in the arms are overbuilt to ensure they keep functioning smoothly over a lifetime of hard use.
The wheel trays on the HoldUp are fully adjustable to ensure that you have all the space you need when mounting bikes with mammoth handlebars, such as a 29er. To adjust a wheel tray, loosen the 4 bolts where the tray attaches to the rack base and slide the tray left or right to achieve the desired spacing. Retighten the bolts and you're ready to roll with optimum handlebar clearance and no fear of bike-to-bike contact during transport.
The HoldUp has a cable lock built into the end of each pivoting arm. These cables loop through your bike frames and attach to posts on the bike rack arms to secure your bikes in place. The cables store in the arms when not in use.
The rack also has a HitchLock hitch pin that allows you to lock the rack to your vehicle. The threaded pin also works as an anti-rattle device to reduce noise and movement of the rack when it's mounted in your trailer hitch receiver.
The cable locks and HitchLock hitch pin include keyed-alike Same Key System (SKS) lock cores. These cores can be swapped out to make all your Yakima products keyed alike.
The HoldUp stores more compactly than similar platform-style racks, and features a spring-loaded pin at the base that lets you fold the rack up against the rear of your vehicle when it's not in use. First rotate the front wheel holders inward and tilt the rear wheel holders inward, then rotate the pivot arms down and use the ratcheting hooks to secure the arms to the rear wheel holders. Once the arms are in place, pull the pin and fold the rack up against your vehicle.
The same pin tilts the rack down, while fully loaded, so you can gain access to your vehicle's rear cargo area without having to unload your bikes.
There is a 2-bike add-on available (Y02446 - sold separately) for the HoldUp that will allow you convert it from a 2-bike carrier to a 4-bike carrier. To install the add-on on your HoldUp, simply remove the endcap from the bike rack base, slide the add-on's shank into the hole on the bike rack, and secure the shank with a bolt that comes with the add-on.
California residents: click here
Exceptional quality. Better than expec ted
So far so good
Assemble was easy
I will send photos when it is not raining
Excellent product.
Great rack. Great price. Delivered to my door. Enough said.
Took quite a while to receive. When I did, a small plastic piece that secures the wheel was broken. Did not notice this until loading bike for the first time. I emailed, but received no response. So I've had to use a bunji cord since day 1
Great product and excellent customer se rvice
The product fits like a glove, but for my hitch.
I carry 4 eBikes without any problem.
Love it. Thank you. super heavy but sturdy. I was hoping it would be easy to take off and put on at a moments notice.
Built solid, and secure.
A great addition for any family that loves their bikes :)
Condition: Like New
Notes: May have damaged packaging or minor cosmetic blemishes.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.