Does the Replacement 2" Hitch Shank for Yakima HoldUp Bike Racks Work w/ the Older Gray Ones?

Question

Question:

Will Replacement 2 Hitch Shank for Yakima HoldUp Bike Racks Part Number: 8880580 work with the older grey version of this rack?

asked by: Daxter G

0

Expert Reply:

Hey Daxter. The Replacement 2" Hitch Shank for Yakima HoldUp Bike Racks item # 8880580 is designed for the following bike racks:

Yakima HoldUp Bike Rack for 2 Bikes - 2" Hitches item # Y02443

Yakima HoldUp Bike Rack for 4 Bikes - 2" Hitches item # Y02443-2

Yakima HoldUp Bike Rack for 2 Bikes - 1-1/4" Hitches item # Y02445 - converts it to a 2"

I can't find any information on them fitting the older gray models but I went and found some measurements for the item # 8880580 and attached a diagram below. I recommend comparing these dimensions to your bike rack to see if they match up.

Do you see a part number or a model number anywhere on your bike rack?

expert reply by: Jerred H

0

Hitch Shank for Yakima HoldUp Bike Racks
(click to enlarge)

Daxter G.

10/8/2025

I will measure and compare the two and let you know

Jerred H.

10/9/2025

@DaxterG Sounds good.

Answer 1

Thank you for the photo of your older Yakima hitch bike rack for which you want to confirm the fit of replacement shank/tongue assembly #8880580. Yakima confirmed the fit of this part on your rack. You may also need Hitch Bolt #8890200 to secure the…

view full answer...

Answer 2

Hey Lee! The Replacement Tilt Pull Pin #Y39FR is the right part for the HoldUp. However, based on your description it sounds like you need the Replacement Latching Spring Pin #8880582, is that correct?

view full answer...

Answer 3

When replacing the spine for the Yakima Hold Up The Replacement Spine for Yakima Plus 2 2-Bike Add-On for Yakima HoldUp #Y8890279 will work for the 2 bike add on. If you are looking for just the original spine for the Yakima HoldUp bike rack then you…

view full answer...

Answer 4

If you take a close look at the Replacement Latching Spring Pin part #8880582 you will see that the cylindrical body has two notches on either side. If you take an opened ended wrench and place it over the body while aligning it with these notches…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Does the Replacement 2" Hitch Shank for Yakima HoldUp Bike Racks Work w/ the Older Gray Ones?

Product Page this Question was Asked From

Continue Researching