What our customers are saying:
Very easy process, good prices and my products were shipped on time and were delivered on time. The instructional videos online helped make installation easy!
Ryan
Portland, OR
Videos
for BOLT Locks
Help Articles
Expert Answers
I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we…
The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…
That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we…
If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…
The best modern day size replacement option we have for a 6.00-16 is a 235/80-16 which measures 30-7/8" diameter x…
The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.
What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
The Solera Gas Strut part #LC280343 is designed for Lippert-Solera branded awnings. That said, it should be able to be used with others but…
Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.
I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
Generally speaking, the lube plate will need to cover the skid plate on the 5th wheel hitch. There are some pin boxes out there that will recommend a specific lube plate but most of the times this classification will be from the 5th wheel hitch…
The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the SAE A P2 DOT 14 and would be what…
Search For Custom Fit Ram ProMaster 3500 AccessoriesSelect A Category Below
Towing
Ram ProMaster 3500 Trailer Hitch
Ram ProMaster 3500 Trailer Wiring
Ram ProMaster 3500 Brake Controller
Ram ProMaster 3500 BOLT brand vehicle and hitch locks
Cargo Control
Ram ProMaster 3500 Roof Rack
Ram ProMaster 3500 Ladder Rack
Ram ProMaster 3500 Trunk Bike Rack
Performance Accessories
Ram ProMaster 3500 Air Filter
Ram ProMaster 3500 Suspension Enhancement
Ram ProMaster 3500 Transmission Cooler
Ram ProMaster 3500 Performance Chip Tuners
Ram ProMaster 3500 Vehicle Lights
Ram ProMaster 3500 Tire Chains
Ram ProMaster 3500 Fluid Filters
Ram ProMaster 3500 Vehicle Sway Bars
Ram ProMaster 3500 Salt Spreader
Ram ProMaster 3500 Vehicle Engine Heaters
Ram ProMaster 3500 Cabin Air Filter
Vehicle Trim
Ram ProMaster 3500 Floor Mats
Ram ProMaster 3500 Nerf Bars - Running Boards
Ram ProMaster 3500 Side Window Vents
Ram ProMaster 3500 Van Cargo Mat
Ram ProMaster 3500 Vehicle Seat Covers
Ram ProMaster 3500 Windshield Wiper Blades