Hey Cody! The brake controller I recommend for your setup is the Redarc Tow-Pro Liberty Brake Controller #RED74CR. The Liberty is simple, reliable, and has a really clean look once installed. The main unit is hidden so the only thing you see is the…
Hey Joe, thanks for all of the details you mentioned. The Bulletproof Hitches Safety Chains part #BPH94MR that you referenced would be exactly what you are looking for. These are 38 inches long and are 5/16 inch in diameter as well. For a set of…
It is perfectly safe to use a reducer sleeve like the Curt #C45405 to fit an accessory with a 2" shank into your 2-1/2" trailer hitch receiver. We do have options for you to use a ball mount with a 2-1/2" shank for when you want to tow…
To get the Dexter Zinc-Plated, Leverlock Coupler #T4845000 in a higher weight rating you'll need to bump up to a hydraulic actuator like what we see with part #DX89FR which has a 7.5K weight rating. For an alternative standard coupler solution I…
It really depends on your setup, if the safety chain loops on your tow vehicle are spaced far apart then you will need more slack to make a tight turn then if they were closer together. What I would recommend you do is connect your trailer to your…
There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…
If you plan to do some towing with your 2008 Ford Taurus X I would recommend going with a Class III hitch like the Draw-Tite Max-Frame #75299, which has been confirmed to fit your vehicle. Class III hitches have more capacity than Class II hitches…
Good question, Carla. This version is zinc-plated only, without a secondary powder coat layer. That zinc finish is strong on its own and helps prevent corrosion, especially in freshwater or light salt environments. Most brake actuators are either raw…
We have ball mounts similar to the B and W part #BWBMHD30012 that you referenced that fit a 3 inch hitch like the Buyers Products part #BP27FR which has a 2-1/2 inch rise and 4 inch drop.
Your 2015 Winnebago Brave is built on a Ford F-53 chassis which means for a brake controller install harness you'll need the part #3035-P. The connector on your motorhome is tucked away behind the instrument cluster and can be tough to find. Ford…
I went out to the warehouse and found that the thread of the bolts in the Hardware Kit #DM6166 you referenced is about 1-3/4" long while the overall length of the bolts is 2-1/8" which you can see in the attached photo.
An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…
Filters
