Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I recommend an axle-less system for your trailer. The axle-less systems can be mounted to the trailer frame. This means you do not need the springs and hangers and you aren't restricted by the width of the trailer frame. If you need…
view full answer...The CE Smith U-Bolt Kit for Mounting 1-1/2" Square Trailer Axles #CE23102 that you referenced includes two u-bolt plates, 8 nuts and washers, and 4 u-bolts. In other words it comes with two sets and not just one like you asked.
view full answer...The correct wedge for your B&W Patriot 5th Wheel Hitch #BWRVK3200 and Lippert Turning Point pin box is the Wedge Block for Lippert Turning Point Pin Box Item #LC79UD.
view full answer...For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…
view full answer...One of the biggest culprits that will not allow the latch to go down as far as it originally did is because there is dirt or debris in the mechanism. Also if it is really dry that can effect the latch. I first recommend checking for any signs of…
view full answer...Jeep recommends disconnecting the negative battery cable when flat towing to prevent the battery from draining. When you flat tow your Wrangler, the ignition must be left in the ACC position. This would leave certain electronic components on that…
view full answer...The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…
view full answer...I called and emailed JR Products multiple times with no response so instead of purchasing the Quick Links - 1/2" #37201345 I recommend going with the Curt Threaded Quick Link - 1/2" Diameter #C82932, which have a safe working weight load of…
view full answer...The seal replacement for your 22333 kbn is the Grease Seal - Double Lip #GS-2250DL. This is a direct replacement with a 2.250" inner diameter and 3.376" outer diameter.
view full answer...We cannot recommend using anti-seize compound when installing the Draw-Tite #DT85MR on your 2021 Nissan Rogue. Though it is rare, bolts can back out when this is used. Especially when used to attach to something that will vibrate and move around a…
view full answer...The Laclede safety chains part #1483-535-04 are made in the USA and have a 5,400 lb capacity per chain. These also have a clevis style hook. Check out the review video I attached for more info as well.
view full answer...That's a good question, because working load limits (WLL) can be somewhat confusing, but I can explain it for you. The 9,200 lb WLL of the Titan Chain Ratcheting Load Binder for 3/8" - 1/2" Thick Chain #TCRB10 simply means that the…
view full answer...Related Searches
Filter Your Search
Contact and Help