Result: peterson

I do have a solution, but the Peterson Thin Line #427400 doesn't have an LED equivalent. I could recommend a different light but that would require drilling new holes to get it mounted. What you can do instead is swap the bulbs to LED using the…

The Peterson LumenX LED Trailer Tail Light #M822R-7 does not include the wiring harness. They are sold separately. The correct wiring and plug for this light will be part #431-491.

The Replacement Lens part #A68RB that you referenced measures 3-1/2 inches long by 1-1/8 inches tall. If the lens you are looking to replace matches these dimensions then this would work for you. The part number for the light this lens is designed…

We don't offer a plug and play trailer harness that would plug directly into the Peterson #435800 trailer taillight. The lamp includes a 3 pin pigtail that would plug into the rear of the lamp which would wire directly into the trailer wiring. If…

So what you have currently is our part #435800 which we have a replacement LED style light for with the part #M826R-7. For an install grommet you'll then want the part #426-18 and for a wiring harness part #431-491 and you'd be set.

The Peterson LumenX LED Trailer Light #M826R-7 should replace your Peterson #435800 without issue. That being said, though they are the same diameter, the grommet may not be able to be reused. I suggest also getting #426-18 just to make sure you are…

The replacement reverse lock out you are looking for is the part #TK71-755-00. This would allow you to use the same adapters and fittings you have now.

I spoke with my contact at UFP Dexter and he said that your 41062 hub uses inner bearing 031-030-02, outer bearing 031-032-02, and seal 010-181-00. This is the equivalent of inner bearing #25580, outer bearing #LM67048, and grease seal #GS-2125DL…

We spoke with our contact at UFP Dexter and he said that your 41062 hub uses inner bearing 031-030-02, outer bearing 031-032-02, and seal 010-181-00. This is the equivalent of inner bearing #25580, outer bearing #LM67048, and grease seal #GS-2125DL…

The Peterson Piranha LED 2-1/2 Inch Round Trailer Clearance Light, 3 Diode #162R light that you referenced is certainly a bright trailer light. This 3 diode LED light will be brighter than a standard trailer light for you. I have attached a review…

The Optronics rubber mounting ring #A45GB will fit into the hole that is 4-1/2 inches round, but the thickness of the mounting ring is 1-1/16 inches in depth. So if your plywood panel accommodates this amount of depth, then this rubber mounting ring…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…