Result: brake controller kit

The wires exiting the rear of your controller serve the following functions. The blue wires carries the brake output from the controller, the white wire is the ground, the black wire supplies 12 Volt power, and the red wire is tied into the vehicle…

Yes, our 7-Way Kit #ETBC7 will connect into your factory 4-way on your 2024 Subaru Crosstrek. This means you will not have to splice into the tail lights. The kit does include universal wiring for both a charge line and Brake Controller #RED52VR…

The best option for you to provide a maintenance charge on your trailer battery would be to upgrade to a 7-way trailer connector on both the vehicle/trailer and then run a wire from the connector to the battery on both the vehicle/trailer. In order…

The appropriate parts you need to transfer the Tekonsha Prodigy P2 #90885 to your 2019 Ford F-150 depend on if you have a factory 4-pole plug or a factory 7-way plug already installed. If you have a factory 4-way, you will need the following parts: -…

To use the electric brakes on the trailer, you will need a brake controller to actuate them. I can highly recommend the Tekonsha Prodigy P2, part #90885. The P2 is our best seller, it is very easy to use and set up. You will also need one of our…

There are a few differences between the Universal Installation Kit part #ETBC7 and the 7-Way RV Upgrade Kit part #ETBC7L. The biggest one is that part #ETBC7 comes with both the power and brake output wire you will need to run to the cab/battery…

For your 2020 Hyundai Palisade Limited edition you will need a wiring kit to transfer the light signals to your trailer, the pre-wiring provides a plug for the trailer wiring to hook up. I recommend Curt T-Connector Vehicle Wiring Harness #CU94FR. It…

Thanks for the pictures you sent! It looks like you don't have the right plug under your dash which is due to not having the factory tow package on your 2020 Ford Ranger. That's ok, since there's still a solution to adding brake…

To install a trailer brake controller on your 2014 Jeep Wrangler Unlimited with the factory tow package you will need the Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers #5506. There is not a plug and play adapter made your…

Yes, per the installation instructions, your 2014 Nissan Pathfinder with the Controller Area Network, or CAN Bus system, it is recommended by the manufacturer that you use the 30-amp circuit breaker kit #331-CBK30-EB. This, along with your Redarc…

Your 2021 Hyundai Santa Fe will need a 7-way to accomplish this so you'll have two options; if you have the factory tow package you'll have a connector that your 4-pole wiring is connected to that you can swap over to the Curt T-Connector…

In order to actuate the trailer brakes, you'd need a brake controller installed in the vehicle and a 6 or 7-way trailer connector. A 4 pole flat wiring harness like the #18002 you'd looked at carries 4 circuits- right turn/brake lamp, left…