I can indeed; the correct replacement for your 8-207 Dexter hub and drum is the following: - Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 #84546UC3
I would be happy to go over how to figure out which bearings your 2014 Aluma 8113 SR and 2012 6310H BT use, but this is not information we have on hand. To determine the bearings used on each trailer you will need to remove a hub assembly and look…
The only difference between the Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear #RVLG-8HDL that you mentioned, and the Landing Gear Set #RVLG-8000 is that #RVLG-8HDL comes with the handle, whereas if you were to go with…
Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…
In order to install a front mount trailer hitch on a 2018 Ford F-350 you will need to make some slight modifications which includes the EcoHitch Hidden Front Mount Trailer Hitch Receiver part #306-X7904. That said, there is no way around this and the…
Sway controls are designed to be used in situations where sway is a direct result of some type of road condition, like high winds or large vehicles passing. If you have sway with a trailer under normal towing conditions, sway control will most likely…
When the display flashes a d.C. code, it means no trailer is connected (or at least that's what it's detecting). This could be either because the trailer connection has become unplugged, there is a bad pin, a bad wire or the trailer brake…
We had the chance to install the Fastway coupler lock part #FA86-0015-318 on an actuator like your UFP A-60 and found that it fit and worked well. Check out the picture I attached to see the lock installed on the coupler.
Thank you for the picture of your Kedu HY60D switch, the Single Momentary Reversing Switch #37213865 has the same 4 prong connection on the back as your pictures. The cutout dimensions for this switch are 0.835" tall x 1.457" wide.
We have ST145/R12 trailer tires with a load range E, the Kenda Karrier S-Trail #AM10140. If you wanted to go to a larger tire and wheel you could do so but you would need to ensure you have the needed clearance of about three inches from your trailer…
Appreciate all that info, and since leaf springs flatten over time, you will want to get one a bit shorter than the 25-1/4 inch eye to eye measurement. For a 6,000 lb replacement the best option is the following: - 4-Leaf Double-Eye Spring for…
The LED Trailer Mini Clearance and Side Marker Light with Grommet #MCL10AKB you were looking to install is designed to fit a 3/4" hole. When drilling this hole just be careful that there is nothing behind the area you are drilling. Once drilled…
Filter Results
