Search: GOOSENECK COUPLER > Gooseneck Coupler >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…
view full answer...Hey Ashley, welcome back! Based on what you mentioned the B and W Defender part #BWGNC4250 would work as it's a round coupler designed for a 4 inch diameter outer tube and has more than enough weight capacity as it is rated for 25,000 lbs. But if…
view full answer...Welcome back John! I'm going to need a bit more information to confirm the MORryde GooseTech item #MR57MV is the correct one. I checked with the manufacturer and your 2024 Dutchman Astorian 230ML 5th wheel trailer comes standard with a Curt…
view full answer...Hey Will! The square tube on the Bigfoot Hydraulic Trailer Jack #BF94FR is 4" x 4". What kind of trailer do you have?
view full answer...Hey Travis! The right MORryde GooseTech depends on the pin box bolt pattern and GVWR of the Solitude 310GK. If it is a little older it probably has a Lippert 1621, I believe the newer models use the Lippert Rhino. You can ask whoever you're…
view full answer...Hey Fred! You will need to take some measurements to determine if you will have enough clearance with the B&W Gooseneck Pin Box #BW23RV. You can use the following formula: (A + B) - C = Clearance A = Distance from the gooseneck ball center to the…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...Hey Michael! The Curt #C93VV does seem low since it is a Class III. However, that is accurate according to Curt. It looks like the connection to the receiver tube is probably the week point, and it is the same as the Class I but with a 2"…
view full answer...Hey Brandon, Leaf springs are not trailer specific, so we would have to get some measurements based on your current setup. I've linked below our article on how to measure the old leaf springs and then that will help us to get you the correct…
view full answer...Hello Danny, Does that mean that your trailer is bigger than all the others, just like everything else in Texas..... bad joke, I know. I have not heard of any issues with the Texas Pride and not being able to use the Demco eZ-Latch Gooseneck Coupler…
view full answer...Mark, I hear you - those heavy manual sliders are a chore. The important thing to know is that the Gen-Y Nomad doesn’t add any turning clearance. It matches the geometry of a standard fixed pin box, so whatever cab clearance you have today without…
view full answer...Hello Eli, thanks for reaching out. Yes, the Demco EZ-Latch Gooseneck Coupler #DM43KV is safe to use on a dump trailer. The key thing to understand is that the weight of the trailer is still carried by the ball, not by the latch itself. The EZ-Latch…
view full answer...Filters
- 42 results
Vehicle Fit
Filters
