bing tracking image
  1. RV Interior Lights
  2. Command Electronics
  3. Dome Light
  4. LED Light
  5. Surface Mount
  6. No Switch
12V RV LED Puck Light - Surface Mount - 3" Long - White Trim
Command Electronics

12V RV LED Puck Light - Surface Mount - 3" Long - White Trim

Part Number: 328-K-1003W
In Stock
ChristmasTree SantaHat Arrives before Christmas SantaHat ChristmasTree
$12.14
RV Interior Lights
Add to cart
zoom in icon
slider vertical icon
zoom out icon
Comment field cannot be left empty.
Name field cannot be left empty.

Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.

Error submitting comment. Please try again momentarily.

Product Images

Need help with installation?
Locate installers near me
Surface-mount puck light brightens up a closet, walkway, or kitchen countertop in your RV. Warm white LEDs are more energy efficient, last longer, and burn brighter than incandescents. The light turns on and off when wired to a switch. Great Prices for the best rv interior lights from Command Electronics. 12V RV LED Puck Light - Surface Mount - 3" Long - White Trim part number 328-K-1003W can be ordered online at etrailer.com or call 1-800-940-8924 for expert service.
  • All Info
  • Reviews (19)
  • Q & A (0)
  • Videos (2)
  • Photos

Command Electronics RV Interior Lights - 328-K-1003W

  • Dome Light
  • LED Light
  • Surface Mount
  • No Switch
  • 12V
  • 3 Inch Diameter
  • Warm White
  • White
  • Command Electronics

Surface-mount puck light brightens up a closet, walkway, or kitchen countertop in your RV. Warm white LEDs are more energy efficient, last longer, and burn brighter than incandescents. The light turns on and off when wired to a switch.


Features:

  • Puck light is perfect underneath an RV kitchen cabinet or inside a closet in your RV
  • Included energy-efficient, warm white LEDs last longer and burn brighter than incandescent bulbs
  • Frosted plastic lens is less likely to shatter than a glass lens
  • Durable, white polycarbonate plastic construction
  • Easy, bolt-on installation onto the surface of your ceiling or wall - hardware not included
    • 2-Wire design with built-in polarity correction - white for ground and black for power
    • White trim flange included for a clean, finished look


Specs:

  • Overall dimensions: 3" diameter x 1/2" deep
  • Mounting hole spacing (center to center): 2"
  • Wiring length: 5-1/2"
  • Operating voltage: 10V - 30V DC
  • Wattage: 2.5 watts
  • Power draw at 12V: 0.21 amps
  • Light output: 204 lumens
  • Color temperature: 3,300 Kelvin
  • Number of LEDs: 6
  • 1-Year limited warranty


Command Electronics K-1003W LED RV Interior puck Light Measurements

Need extra light on your kitchen counter for when you need to prep meals for the family? Or perhaps you need a light in the hallway so you can see where you're going when walking to the bathroom in the middle of the night? This puck light has warm white LEDs that give you a softer, accented light underneath a kitchen cabinet, in a closet, over a reading nook or chair, or in a walkway inside your RV or camper.


Command Electronics puck Light LEDs

LEDs are more energy efficient, last longer, and burn brighter than lights with incandescent bulbs. You won't have to worry about replacing bulbs that have brittle filaments. And because LEDs draw minimal power, the light won't drain your battery, overload your circuits, or produce too much heat.


Surface-Mount, Bolt-On Installation is Easy


Command Electronics puck Light Installed

This surface-mount puck light is incredibly easy to install as an upgrade or direct replacement of your existing light. To access the bolt holes, pull the lens up and away from the housing. Do not use any tools to remove the lens, as it will crack. Then, using hardware (not included), bolt the housing onto the ceiling, wall, or cabinet before re-installing the lens. And the included white trim flange covers the bolt holes to provide a clean, finished look.


The light has a 2-wire design that hooks up to ground (white wire) and power (black wire). This design has built-in polarity correction that ensures the light operates consistently. If you want to be able to control the brightness of the light, you can connect it to an LED-compatible dimmer switch (not included).



K-1003W Command Electronics 12 Volt LED RV Pancake Light - Surface Mount - 6 LEDs - White Trim





Video of 12V RV LED Puck Light - Surface Mount - 3" Long - White Trim

Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.




Video Transcript for All You Need to Know About the 12V RV LED Puck Light

Speaker 1: Today we're going to be taking a look at the LED RV Interior Light with Six Diodes. It's available in white with a switch. It's also available in white without a switch. It's also available in a black housing. This surface mount light is going to be great for your ceiling or underneath your cabinets in your RV, camper or fifth wheel trailer. It's also ideal to use in those bunk bed areas of your RV or camper where there's little to no headroom.

Since it is LED, it's going to be brighter. It's more efficient, and there are no bulbs to replace. Another great thing about LEDs is there much safer than traditional bulbs, and they're not hot to the touch. The six diodes are going to provide 204 lumens, so they'll be great for those small areas in your RV or camper.If you picked up the one with the switch, it's located right here in the center, and it's an easy operation. Some RV or campers have a separate switch, so you may opt for the one without the button which will give you a cleaner look.

It's three inches in diameter and 1/2 inch deep. It simply wires into your RV or camper's new or existing 12-volt system.I'll go ahead and show you how to get it installed. I'm in the bottom bunk of my travel trailer. I've already gone ahead and removed my single dome light. It was large and bulky.

I'd like something a little bit more low profile and easy, so I'm going to be installing this low profile light here. I pulled my wires through. Our old wiring used some wire nuts so we're just going to go ahead and reuse these, and since we're hooking up an LED light, it doesn't rightly matter which wire goes to where. We're going to go ahead and do white to white, so we'll take both of our white wires here. We'll put them all together, and then we'll go ahead and screw on that wire nut.

Make sure it's nice and tight and give it a good pull. Make sure they're not coming out. Then we'll just repeat the same process with the brown and black wires. Perfect. Now we can turn on our power and check it out. I'd say it works great.Now, let's finish up our install. In order to mount the light to the ceiling, we'll need to remove the lens. We can just take a screwdriver and pop it out just like that. From here, we'll just tuck our wiring back up into the ceiling like so. As you can see, I've got a series of holes from my previous light. I'm going to try to hide those as much as I can, and I'm going to use my existing hardware from my other light. If you're going to be using your hardware from your old light, you do want to be sure that it's low profile. That way when you go to put your lens back on, it'll fit right over them. Most of the hardware used in your RV or camper is pretty thick and bulky. You want to be sure when you use this light you switch to a low profile hardware. That way you can get your cover back in place. Perfect.That's going to complete our look at the LED RV Interior Light with Six Diodes.

Customer Satisfaction Score:


Customer Reviews

12V RV LED Puck Light - Surface Mount - 3" Long - White Trim - 328-K-1003W

Average Customer Rating:  4.6 out of 5 stars   (19 Customer Reviews)

Surface-mount puck light brightens up a closet, walkway, or kitchen countertop in your RV. Warm white LEDs are more energy efficient, last longer, and burn brighter than incandescents. The light turns on and off when wired to a switch.

by:

We received the light quickly and it was a perfect fit. Would definitely order from etrailer again!



by:

I had an LED recessed light burn out in my Jayco travel trailer. I could not find a similar replacement. I purchased this product because it had the same LED element. I removed the element and installed it into my existing recessed light. It fit perfectly and is operating correctly. I received the replacement light on the day it was scheduled. I'm sure I will be using etrailer again. Thank you for your great service. Paul



by:

Small and dainty, but very effective.



by:

These were exactly what I needed to replace LED ceiling lights in my motorhome that were gradually burning out. The strainer description was very good and the lights arrived just a couple of days after I placed my order. Replacement was easy.

Ed A. profile picture

Ed A.

8/6/2021

Great. I replaced overhead lights in my motorhome and the new lights work very well. None of the leds have burned out.



by:

Packaged right, all there and on time.



by:

Great price point and product. Actually ordered a handful more

Brian Z. profile picture

Brian Z.

3/27/2020

Lights are great. We’ve used them probably 50 times in our camper.. very efficient. Etrailer is always a pleasure to work with!



by:

did not arrive



by:

Good replacement led/light.



by:

Great product and worked well as a replacement unit. Thanks!!



by:

Fast shipping, Dome light works perfect ly



by:



by:

The ordering was easy, the delivery was faster than estimated and the light was exactly the same as the one I I was replacing. Also, the price was less than other web sites for the same or similar items.



by:

Worked out great. Thanks



by:

Service is great and product as describ ed.



by:

They work great



by:

As advertised. Works well.



by:

Nice bright light



by:



by:


19
19

See what our Experts say about this Command Electronics RV Interior Lights

  • Recommended LED Lights For Under Cabinet Lighting In 5th Wheel Trailer
    I may have an option for you, but there is not specific lights for undercabinet lighting in an RV like yours. If you'd like each individual light to have a switch I'd go with the # 328-K-1003WS which is a 3" surface mount light that'll work perfectly for under cabinet lighting. These have a built in switch so no need for a wall switch, and you can turn all of the lights on or have some on and some off. If you'd rather wire a single switch to power all of the under cabinet lighting then...
    view full answer...
  • Dimmer Switch for 12V RV LED Puck Light
    The 12V RV LED Puck Light # 328-K-1003W works with LED compatible dimmer switches. I recommend one of the following: -LED Dimmer Rocker Switch - On/Off - White # 37215205 -LED Dimmer Rocker Switch - On/Off - Black # 37215225 For an option with a smaller cutout: -RV LED Light Side-Slide Dimmer Switch - White # 37205-12325 -RV LED Light Side-Slide Dimmer Switch - Black # 37205-12315
    view full answer...

Do you have a question about this RV Interior Light?


Info for this part was:

Employee Andrew K
Video by:
Andrew K
Employee Cole B
Installed by:
Cole B
Employee Hayden R
Installed by:
Hayden R
Employee Chris R
Video Edited:
Chris R
Employee Mary K
Updated by:
Mary K
Employee Wilson B
Updated by:
Wilson B
Employee Daron K
Edited by:
Daron K
Employee Brian T
Written by:
Brian T

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.


Product Experts Available Now!
Call 1-800-940-8924