Result: Chock

Do you mean the min and max of the height of the jack legs or the strap that runs between the two legs?

The Kenda Karrier ST225/75R15 Radial Trailer Tire - Load Range E #AM10303 would work just fine to replace the Westlake ST235/75R15 tires currently on your trailer but will be about 1/2" narrower and shorter. The #AM10303 has a load rating of…

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

Different manufacturers sometimes have different philosophies about the set-up process of a weight distribution system on a vehicle with factory air shocks. I can share with you the process we have found to work well for us when setting up a weight…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

The RhinoEXTREME RV Sewer Hose w/ Swivel Fittings #CAM39861 referenced in your question is essentially an upgraded version of the RhinoFLEX hoses, such as #CAM39761. The primary difference is that the RhinoEXTREME features a thicker sidewall that…

Yes, the bayonet fitting of the part #CAM39863 that you referenced will fit the bayonet style fitting of the #CAM39761.

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

The Replacement Caster Wheel for Ultra-Fab Manual 2" Trailer Jack - Qty 1 #UF49-954035 will fit an inner tube diameter of 1-3/4 inches. This will be the best fit for your inner tube with 1-5/8 inch diameter. The Removable Wheel for…

The Dutton-Lainson A-Frame Trailer Jack #DL22530 is currently our only manual A-Frame tongue jack with a 2" outer tube. The Lippert Quick Drop Tongue Jack #LC733926 that supersedes your 423192 jack along with our other jacks have all gone to the…

The inner lip of the Snap Pad Jack Pad for Camper Jacks w/ 5-1/2" Round Feet #SN97FR that grips onto the jack foot has a 5-1/8" measurement from one edge to the other so you'd have a bit more than 1/8" of the lip covering the jack…

That is a good question, and you will need to use three backing plates for each 5 foot section of e-track, so the exact part you will need is the following: - etrailer E-Track Backing Plates w/ Hardware - Qty 3 #e46RR These will fit perfectly with…