Hi Matt! The #LM48548 inner bearing is typically seen in the AH25555F agricultural hub, but not with an #L44649 outer bearing. This is a very odd hub/spindle you have, especially with that bolt pattern, but I am fairly sure it is a variant of…
I have attached for you a list of the replacement parts that are available for the Bulldog Powered Drive Trailer Jack part #BD500199. I am not sure which part in particular that you are referring to but if it is not listed below then you would…
Hey Dusty, I emailed the manufacturer to get the dimensions you are looking for on the #ABS56FR and the overall length is 5-5/32” with the hole spacing of 3-29/32” center to center.
The Saf-T-Lube system is similar to the EZ lube spindles that we do carry which allows you to pump grease to the middle of the spindle bearing area through a grease fitting at the end of the spindle. If you look far enough online you'll see…
The key here is that the functions are in the correct locations. Wire color is going to vary from manufacturer to manufacturer which is why you should always wire by function and use a circuit tester like #PTW2992 or #PTW 2993 when wiring in a…
Hello David, thanks for reaching out. It is possible to switch your trailer over to a lunette ring/pintle hitch system. Basically you will need to replace your current A-frame coupler with a channel coupler like part #LR76VR. This will allow you to…
Your 2013 Nissan Titan came from the factory with a quick-connect port under the dash for connection of a brake controller like the Hopkins Agility #HM47294. That quick-connect 4-wire harness for a Hopkins controller is part #HM47635. As long as the…
I went out to the warehouse and pulled Pins and Thumb Clips #EQ95-01-9415 to measure them for you. The diameter is 3/8 of an inch. The usable length is just under 2-1/2 inches (2.45 inches). And the opening is 2.46 inches by 1.5 inches.
My contact at Curt Manufacturing advised that they do not offer the replacement Wire Lock Lynch Pins (shown as part number 10 in their instructions, which are linked) that secure their TruTrack's trunnion bars at the head end but he said…
We offer 3/8-inch diameter Replacement Snapper Pin #JFC-PN whose measurements are noted in the photo I linked for you. This item matches the original; I confirmed by going to our warehouse and measuring the pin included with your Husky Super Brute…
My contact at Atwood recommended using a pin at least 3/8 in diameter and 2-3/4 inches long. I'd recommend using a snapper pin, part #JFC-PN which has those dimensions.
The only difference in the Demco Channel Tongue Trailer Couplers #DM16080-95 and #DM15931-95 is going to be the bolt pattern. One will have the 5-Bolt hole pattern and the other is going to have 4-Bolt holes. I have included images below showing the…
Filters
