Trailer Wiring Harness for 2004 Mitsubishi Endeavor

Updated 10/02/2014 | Published 10/01/2014

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(32)

$33.04

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(29)

$431.07

1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs

(2634)

$11.68

2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs

(1361)

$11.31

Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs

(3886)

$30.95

Question:

Im thinking about getting T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector - Mitsubishi Endeavor, 2004 My Endeavor does not have the trailer package. I was reading on other sites that their cable would not work because I did not have the correct wire harness on my vehicle. Can I just plug your harness into my existing connectors? Thanks

asked by: Dan

Expert Reply:

The connector on the Curt # C56039 T-Connector would indeed plug into the trailer connector plug located in the cargo area, under the carpet next to the driver's side wheel well as shown in the photo. Just to be sure, I contacted our representative at Curt, who assured me that the # C56039 trailer wiring harness is compatible with all models of the 2004 Mitsubishi Endeavor.

If you don't yet have a hitch, I'd recommend the Curt Class III # 13569. This hitch has a bolt-on installation and will provide you with a 2" hitch receiver, which is the most common size used for hitch mounted accessories.

If you don't already have a ball mount and trailer ball, you can use the # D-4 ball mount, Hitch Pin and Clip, # PC3, and # 63845 for a 2 inch ball or # 19260 for a 1-7/8 inch ball.