Can I Purchase Just the Leg for My Lippert Ground Control 3.0, or do I Need the Whole Assembly?
Updated 02/18/2026 | Published 02/12/2026
Question:
Can I purchase a replacement leg for a Lippert 344792 Ground Control 3.0 Jack and use my existing motor?
asked by: James S
Expert Reply:
Hello James,
I completely understand wanting to make sure you are not spending money on more than you need or ending up with something that changes how your Ground Control system works.
I really wish you could just swap the leg over, but with this setup you will need to replace the entire unit. The good news is the Replacement 24-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System # LC344792 is a direct bolt-on replacement. It will work with your existing Ground Control panel and will not change your menus or require any new wiring or re-learning the system.
What kind of RV is this on? And do you have any trips coming up once we get this fixed?
(click to enlarge)
Wade B.
2/18/2026
I don’t believe so, however I did keep my old motor as a backup one so if a motor does go out I can replace it
Gille
2/18/2026
It is way easier to change the complete assembly it's plug and play, if you want to keep the old motor has a backup you could though.
Product Page this Question was Asked From
Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Correct Replacement Legs for Lippert Ground Control 3.0 Leveling System - 6 Point
- Q&A: What Left Rear and Right Rear Hydraulic Jacks do I Need for My Lippert Ground Control 3.0?
- Q&A: Determining Correct Replacement Right Middle Jack For Lippert Ground Control 3.0
- Q&A: How To Choose the Correct Replacement Rear Jack for a Lippert Ground Control Leveling System
- Q&A: What Control Module do I Need to Replace My Lippert 346005 on My Lippert One Contol?
- Q&A: Replacement Right Rear Lippert Ground Control Jack Leg that is 24-1/2 inches Tall
- Q&A: Replacement Brackets And Legs For A Lippert Ground Control 3.0 Leveling System
- Article: Trailer Wiring Diagrams
- Article: Performance Chips and Modules
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Cliff K.
2/18/2026
It's so easy to just replace the whole unit. I think that's why they don't offer the parts separately. I took the old unit apart just for fun and made a jack out of it, but you would not want to mess with replacing just the motor on your new leg. Absolutely would not be worth the trouble. Cliff