Replacement Brackets And Legs For A Lippert Ground Control 3.0 Leveling System

Updated 08/01/2024 | Published 06/08/2022

Products Featured in This Question

Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set

(126)

$3616.83

Replacement 24-1/2" Left Rear Leg - Lippert Ground Control 3.0 Electric Leveling System

(75)

$592.17

Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1

(176)

$572.94

Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System

(108)

$582.08

Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0

(37)

$207.13

Question:

if i send you picture of my bent one will it help you to identify to see if you have a streight one in stock

asked by: Vince L

Expert Reply:

If the portion of your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 that is bent is the bracket that attaches to the I-Beam you can replace it with the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 # LC349975.

If the bracket on the leg is damaged then you'll have to replace the entire leg. For the left rear leg you'll need # LC305339 and for the right rear leg you'll need # LC344792.

The front legs of the Ground Control 3.0 can be replaced with # LC305340.

expert reply by: Kevin C

Ross G.

8/1/2024

My middle right side leg bracket is bent. It is welded on. If I order this replacement bracket do I need to get the old one removed or could I mount this directly next to it? Understanding it would then be slightly out of line with the bracket/leg on the other side of the 5th wheel. Hoe does this then mount to the I beam? Does it require either drilling holes in the I beam to insert mounting hardware or welding it onto the I beam?

Kevin C.

8/1/2024

@RossG Are you saying that the mounting bracket # LC349975 that sits on the frame is bent or that the mounting welded to the jack leg is bent, or both? If the jack leg is salvageable then you could just have the frame bracket cut off and bolt on the # LC349975 in its place. If the jack bracket isn't reusable then you'd have to purchase an entirely new jack # LC344792 (24-1/2" tall) or # LC428493 (22-1/2" tall).

Rossg

8/1/2024

@KevinC. Yes, both the mounting bracket and jack leg mounting are bent. So I would need to have the frame bracket cut off? Can the new one just mount next to it? If I am having it cut off then I guess doing I could have same shop weld on the new frame bracket.

Kevin C.

8/1/2024

@Rossg The leg placement is specific to ensure that you have proper approach and departure angles so the legs won't hit when going up or down an incline. If you put it next to it you would likely run into issues with the sensors as well as this system can be very finicky. It will cost a bit more to have the new bracket # LC349975 mounted but it'll save you a bunch of time since you won't have to drill through the frame to bolt the bracket in place.