Is There A Thule TracRac SR Ladder Rack Confirmed To Fit A 2023 Toyota Tacoma Long Bed

Question

Question:

I am about to purchase a Tacoma long bed truck. I have always put trac rac sliding rack systems with cantilever on my trucks. Can you let me know what configuration would work on a 2023 Toyota Tacoma long bed.

asked by: John S

0

Expert Reply:

Hey John,

There unfortunately isn't a TracRac SR ladder rack confirmed to fit your 2023 Toyota Tacoma. The fixed-mount TracRac TracONE Ladder Rack # TH27000XT-XK4EX or T-Rac Pro2 # TH37005XT-EX would be the only Thule-branded ladder racks with a cantilever confirmed to fit your Tacoma. These wouldn't have the towers through so you wouldn't have the versatility of the TracRac SR.

If you want to keep discussing ladder rack options let me know what you think below.

expert reply by: Kevin C

0

Chris R.

11/17/2025

Hey John, what did you end up deciding for your Tacoma long bed—did one of the Thule fixed-mount racks with a cantilever meet your needs? Your update could make it easier for the next person trying to find a similar setup.

Answer 1

To carry lumber and tools with your 2023 Toyota Tacoma you are going to want the Thule TracRac TracONE Truck Bed Ladder Rack item #TH27000XTB-XK4B. This fits both the 5 foot beds and 6 foot beds with the deck rail system. The Thule ladder rack system…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Is There A Thule TracRac SR Ladder Rack Confirmed To Fit A 2023 Toyota Tacoma Long Bed

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching