Looking For Threaded Axle Cap For 2-3/4" Opening
Updated 12/22/2025 | Published 10/03/2024
Products Featured in This Question
Question:
Looking for a threaded axle cap to fit a 2 3/4” opening. Prefer a solid cap as this is not an oil bath axle, but a clear cap with a plug is acceptable. Thanks
asked by: Lance
0
Expert Reply:
Hello lance, good to hear from your again. I am sorry to say that we do not offer a threaded axle cap in that size. We offer drive-in caps in that size, such as the TruRyde Zinc Plated Grease Cap # TRDC-275, but nothing threaded I am afraid.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Replacement Oil Cap Kit for AL-KO and Rockwell 10,000-lb to 16,000-lb Axles
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- 3.75 Inch O.D.
- 3.75 Inch
- 10000 lbs Axle
- 12000 lbs Axle
- 15000 lbs Axle
- 16000 lbs Axle
- Dexter
more information >
Continue Researching
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: What Is The Span Or Usable Length Of RV Designer Hitch Pin - 1/2" # RD83GR
- Q&A: Does Lippert 12" Electric Brake Assembly ABS Need To Be Programmed Or Paired For Setup?
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Wiring Diagram for Dexter DX Series Electric Over Hydraulic Brake Actuator
- Q&A: Troubleshooting Stillwell 7k Hydraulic Jack that Raise/Lower
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: The Best Towing Mirrors
- Article: How to Accurately Measure Trailer Leaf Springs
Jesse M.
12/22/2025
Hey Lance, did the drive-in grease cap end up working for your 2-3/4" axle opening? Knowing how it fit could help others looking for a solid option instead of a threaded cap. Your update could make it easier for the next person with the same setup.