Keeping your trailer properly marked is key for safety and legal compliance, and this heavy duty 16-1/2" TecNiq Tri Bar ID light makes it easy. It combines three high-brightness markers powered by 6 LEDs into one sleek unit that exceeds FMVSS 108 standards. The red lens puts out a clean, even light that clearly identifies wide trailers or rear cargo setups, helping other drivers see you in all conditions.
Rough roads and weather can punish trailer lights, but this bar is made to take it. The impact-resistant housing and sealed construction hold up in tough environments where vibration and debris are constant. Whether it’s road spray, dust, or heavy use, this light keeps shining without cracking or fading.
Moisture is the enemy of most lights, but not this one. With its fully submersible design and IP68 rating, it stays sealed tight against water intrusion. That means you can launch boats or haul through storms without worrying about short circuits or corroded connections. Once mounted, it stays watertight and dependable season after season.
Installation is quick thanks to the surface mount design with 6" hole spacing and a 9" pigtail connector. The low-profile body—just 1-1/4" wide and 1" deep—fits cleanly wherever you need it without sticking out or snagging on gear. Hook it up to 9 to 14 volts DC power, screw it down, and you’re ready to roll with bright LED reliability.
TecNiq backs this light with a lifetime warranty, showing how much trust they put in their build quality. Once installed, you can count on it for the long haul without worrying about early failures or flimsy construction.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone, Steve here with etrailer.com. Let's take a look at our TecNiq Tri Bar Heavy Duty ID Bar. It measures 60 1/2 inches long with a nice three red lenses. Folks, you do have six LEDs, two, four, six, and of course you have those three individual lenses there on the 16 1/2-inch long whole light assembly. And the nine holes there in the center are six inches on center. You get a nice nine-inch long sheet of pigtail, and at the nighttime, you can see this is really lit up bright and it's gonna be great for giving you visibility out on the road at nighttime, in the daytime, whenever you need it.
And again, this is a red lens with a black body. It does give you all the ratings and exceeds all the safety standards that are required by law for using any kinda light as such as this. The housing is just plastic, the lenses are polycarbonate, and again, you have that nice pigtail on the back, so it's ready to go outta the box for ya. You just need to purchase some screws separately, if you don't already have some, to mount it. Folks, that is gonna wrap it up for our quick look together at this Tri Bar by TecNiq.
I'm Steven, thanks for watching.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews
Nice!
Easy to install on my boat trailer.
Very bright, works well
The bars look great mounted on the end of mt trailer - thanks!
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.