What Wire Gauge Does The Curt Cold Weather 7-Way RV Style Connector # C23RJ Use?

Question

Question:

What are the wire gauges on this pigtail? part C23RJ Thanks

asked by: Robert

0

Expert Reply:

Hey Robert, thanks for reaching out. The Curt Cold Weather 7-Way RV Style Connector # C23RJ uses a combination of 14-gauge and 10-gauge wire. The black 12V power wire and white ground wire are 10 gauge, while the brown, red, blue, green, and yellow circuits are 14 gauge. The heavier 10-gauge wires are there for the main power and ground circuits since those carry the highest current loads, especially for battery charging and brake systems. The rest of the lighting and signal circuits use 14 gauge, which is pretty standard for a 7-way RV harness.

What kind of trailer were you thinking of installing it on?

expert reply by: Jesse M

0

Curt Cold Weather 7-Way RV Style Connector Wires
(click to enlarge)

Answer 1

The LED Trailer Mini Clearance and Side Marker Light with Grommet #MCL10RKB can be exposed to heat up to 270 degrees before melting the lens. So basically the lens won't melt unless you're camping on Venus.

view full answer...

Answer 2

You can use either of the adhesives for permanently installing the Small Coin Pattern Vinyl Flooring #TS37FR to your utility trailer: - Vinyl Over Wood #TS76FR - Vinyl Over Wood, Metal, or Concrete #TS86FR Both options come in a Gallon tub and…

view full answer...

Answer 3

The best connector type to use with the 40' 18-Gauge 2-Wire Bonded Wire #SWC77FR are the Deka Heat Shrink Butt Connectors #DW05743-10. You'll insert the ends of the wires into the butt connector, crimp it down, and then use a heat gun or a…

view full answer...

Answer 4

Trailer wheels are designed to hold the weight at the lugs. Passenger vehicles are hub centered where trailer wheels are lug centered. The large pilot hole is not an issue at all and there are various size caps like #319EZ that can be used for…

view full answer...

Answer 5

Hey Tim, I believe the part #e29SR would be your best option and is only off by .25 of an inch in overall length. It is a 2 leaf slipper spring with a flat end like you want and for a 1,800 lb trailer axle. What is the axle capacity of your boat…

view full answer...

Answer 6

That's a great question, John! Yes, you can use the etrailer Replacement Fabric #e26QV in place of the Solera Replacement Fabric #LCV000334415. They are both made to work on the same size awning, so the fabric will be the same size and will…

view full answer...

Answer 7

Hi Mark; have you tried looking behind the center dash storage pocket? Technically on the vehicle the location is BH7. It will be similar to the attached picture on an Expedition. You can also take a look at the installation video I attached further…

view full answer...

Answer 8

Hey Bob, great question. It was about 7 degrees here in Missouri this morning, so I can relate to the cold. I do have a good solution for this too. What I would do is replace your current 7-way cord with the Curt Cold Weather 7-Way RV Style Connector…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Emily! The Yakima StraightShot #Y69VR won't be a good fit since you'll run into the same issue with the shallow receiver on your Volvo XC90. Instead, I recommend the Curt Hitch Extender #C45791. This only requires 2" of space behind…

view full answer...

Answer 11

I attached a link to this page that has all of the tire and wheel combos that are aluminum that match your tire size of ST235/85R16 with an 8 lug bolt pattern. For a higher capacity option that looks really nice we have the Provider ST235/85R16…

view full answer...

What Wire Gauge Does The Curt Cold Weather 7-Way RV Style Connector # C23RJ Use?

Product Page this Question was Asked From

Continue Researching