Can Curt Hitch for 2024 Chevy Blazer EV Carry Motorcycle and Motorcycle Carrier

Question

Question:

I would like to use this hitch with a dirt bike carrier. How does the 350 tongue weight translate to the amount my dirt bike and carrier can weigh? The centerline of the motorcycle rail is 20inch from the hitch pin hole.

asked by: Jim

0

Expert Reply:

Hey Jim, so the Curt hitch part # C63ZV that you referenced does have a 350 lb tongue weight capacity like you mentioned and what that means is that the weight of your motorcycle and carrier together have to weigh less than 350 lbs. The length of the motorcycle carrier does not need to get factored.

expert reply by: Jameson C

0

Answer 1

Hey Alex, to install the Curt hitch part #C63ZV you only need to trim the lower plastic cover that you referenced and not the bumper cover at all. Basically you need to put an opening in the plastic cover to allow the hitch opening to pass through.

view full answer...

Answer 2

Hi Todd; for the T-Connector Vehicle Wiring Harness #C44FR on your 2024 Chevy Blazer EV, you can use use a bracket that attaches to the Curt Trailer Hitch Receiver #C63ZV. Just use bracket #18136 and #C42CR; I have added a link below to a video…

view full answer...

Answer 3

Hey Robert, so at this time we do not have an install video for the Curt Hitch part #C63ZV on a 2024 Chevy Blazer EV yet but hopefully we do soon. If you check out the attached install instruction link though you can see that this does not require…

view full answer...

Answer 4

Hi John; even though they use the same frame there is some kind of difference between the two that won't allow the #C63ZV to fit the 2024 Prologue. Curt is working on a hitch for the Prologue which is the #C89RV. We have it up for pre-order but…

view full answer...

Answer 5

Hey Chris; thanks for the question and it's definitely smart to check. I can tell you with 100% certainty that yes, the following Curt trailer hitch does fit your 2024 Chevy Blazer EV: - Curt Trailer Hitch Receiver #C63ZV I went ahead and…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The Fixed Dual Rack Repair Kit #LC84FR goes on the left side of the slide as you look at the slide out from the outside of the camper. So on the drivers side it will be the front of the slide. The Floating Dual Rack Repair Kit #LC26VR is going to be…

view full answer...

Can Curt Hitch for 2024 Chevy Blazer EV Carry Motorcycle and Motorcycle Carrier

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching