Is The CE Smith Bunk Carpet Available In Rolls Larger Than 12 Feet Long?

Question

Question:

Do you have any rolls longer than 12 feet I need to do all my bunks on my ranger trailer

asked by: Lonnie F

0

Expert Reply:

Hey Lonnie, so we do offer a larger roll with part # CE11373 which is an 18' long 18" wide grey bunk carpet. If you are wanting to stick with the 11" wide carpet, I am afraid the 12' long roll # CE11372 is going to be the longest roll we offer. You will just need to get multiple rolls for multiple bunks.

expert reply by: Jesse M

0

Answer 1

We typically try to use 1/2 inch stainless steel staples when we install the CE Smith Deluxe Marine-Grade Carpeting, #CE11372, but 3/8 inch staples will work too. I would not go much shorter than the 3/8 inch staples because you don't want them…

view full answer...

Answer 2

We typically try to use 1/2 inch stainless steel staples when we install the CE Smith Deluxe Marine-Grade Carpeting, #CE11330, but 3/8 inch staples will work too. I would not go much shorter than the 3/8 inch staples because you don't want them…

view full answer...

Answer 3

I checked the instructions for the Demco Solenoid Kit #DM5404 and though it is a little vague, you will want to have the flared inlet attached to the actual brake line and the flat inlet attached to the #6 fitting (which then attaches to the master…

view full answer...

Answer 4

You can pretty easily add an electric lockout to the Titan Model 10 actuator part #T2478100. For that all you would need is the part #T4748800. This will then allow you back up a hill without the brakes locking up.

view full answer...

Answer 5

I spoke to my contact at Titan and he informed me that there really isn't a simple way to lock out the sliding portion of the Model 10 actuators. You would have to either weld the two portions of the actuator together or drill holes through them…

view full answer...

Answer 6

If you have an actuator like the Dexter #T4750620 you looked at, the only way to lockout the brakes is with the electric lockout. If you have a different model it is possible it has a spot for a key on the side like the #DX94FR which would work with…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hello Randy, Great question. For replacing bunk boards on a 20 ft bass boat trailer (like #CE27845), you’ll want 3/8 inch diameter lag bolts that are 1-1/2 to 2 inches long, depending on the thickness of your bunk brackets. Go with hot-dipped…

view full answer...

Answer 9

The longest bunk board set we have is the CE Smith Carpeted Bunk Boards for Boat Trailers #CE27845. These are 84" long x 1-3/4" wide x 3-3/4" tall so they will be a bit smaller than what you're looking for when it comes to all of…

view full answer...

Answer 10

Hey Jeff. The CE Smith Bolster and Swivel Bracket Assemblies item #CE10000G-4 are going to need a 3-1/16" wide on the inside u-bolt that has threads that go down to at least 1-1/2" from the inside of the bolt. The 3-13/16" Long x…

view full answer...

Answer 11

The Stainless Steel Hex Lag Screw #FA74521 contains one 3/8" diameter, 1-1/4" long lag screw.

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Is The CE Smith Bunk Carpet Available In Rolls Larger Than 12 Feet Long?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching