What Size Staples are Recommended for Installing Bunk Board Carpet on Boat Trailer
Updated 08/22/2016 | Published 08/20/2016
Question:
Hello, staple gauge and length for new carpet installation- using air gun. THANKS
asked by: W C
Expert Reply:
We typically try to use 1/2 inch stainless steel staples when we install the CE Smith Deluxe Marine-Grade Carpeting, # CE11330, but 3/8 inch staples will work too. I would not go much shorter than the 3/8 inch staples because you don't want them to work their way out over time. I strongly recommend using stainless steel staples if possible. They will last much longer because they provide the best rust resistance.
I would also recommend uses a hammer to drive the staples all the way into the boards. Especially in areas were there may be extra layers of carpet.
Product Page this Question was Asked From
CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Black - 12' Long x 11" Wide
- Boat Trailer Parts
- Bunks
- Bunk Carpet
- 11 Inch Wide
- 12 Feet Long
- CE Smith
more information >
Continue Researching
- Shop: CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Black - 12' Long x 11" Wide
- Shop: CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards - Charcoal - 12' Long x 11" Wide
- Article: Trailer Maintenance Schedule
- Shop: Replacement Spindle Washer - Tang Type for E-Z Lube
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Shop: 2" Lubed Dust Cap & Rubber Plug - 1.99" x 1.40" x 1.18" - Qty 1
- Shop: Spindle Grease Seal Set for L44649 Inner Bearing and 1.980 Bearing Buddy
- Q&A: Should There Be A Gap Between The Seal and The Inner Bearing In My Hub
- Q&A: Tips for How to Identify a Trailer Axle
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Wiring
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Article: Trailer Wiring Diagrams
- Search Results: trailer tires and wheels
- Shop: Trailer Hitch
- Video: Measuring To Choose The Right Trailer Axle
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer hitch
- Shop: Brake Controller
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Video: All About the Demco Hydraulic Brake Actuator-DM72VR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer jack
- Video: Hands-On with the CE Smith Deluxe Marine-Grade Carpeting for Bunk Boards
- Search Results: trailer lights
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Shop: Suspension Enhancement
- Article: Trailer Lighting Requirements
on Boat Trailer Parts
