How Does The Demco Reverse Lockout Solenoid Kit DM5404 Install?
Updated 01/10/2022 | Published 01/09/2022
Question:
Which port faces the master cylinder,when you look inside the threaded ports they look different one side has a flared inside and the other does not.Does one side go to master cylinder and other to brake line?The offset one is the bypass flow back to master cylinder.
asked by: David D
Expert Reply:
I checked the instructions for the Demco Solenoid Kit # DM5404 and though it is a little vague, you will want to have the flared inlet attached to the actual brake line and the flat inlet attached to the #6 fitting (which then attaches to the master cylinder). I included an image of what this should look like once installed as well. Should help visualize everything.
(click to enlarge)
Product Page this Question was Asked From
Demco Solenoid Kit for Brake Actuators with Reverse Lockouts - Bypass
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Solenoid
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: adhesive
- Shop: Trailer Hitch
- Shop: Demco Solenoid Kit for Brake Actuators with Reverse Lockouts - Bypass
- Article: Trailer Wiring Diagrams
- Video: Demco Solenoid Kit for Brake Actuators with Reverse Lockouts Spec Review
- Q&A: How Many Threaded Ports on Demco Solenoid Kit DM5404
- Shop: Trailer Wiring
- Search Results: manual reverse lockout
- Search Results: reverse lockout solenoid
- Search Results: brass brake line fittings
- Shop: Kodiak Hydraulic Brake Line Kit - Single Axle - 18'
- Shop: Replacement Bypass Solenoid Valve for Demco Brake Actuators - Qty 1
- Search Results: accessories and parts
- Search Results: brake fluid
- Search Results: emergency brake cable
- Q&A: How to Lock Out a Model 10 Actuator When Going to an Electric Over Hydraulic Setup
- Shop: Caliber Bunk Wrap Kit for 2x6 Boat Trailer Guides - 24' Long - Black
- Q&A: Is The CE Smith Bunk Carpet Available In Rolls Larger Than 12 Feet Long?
- Q&A: What Size Staples are Recommended for Installing Bunk Board Carpet on Boat Trailer
- Q&A: Recommended Staple Size for Bunk Board Carpet
- Shop: DeeMaxx Single Disc Brake Assembly - 10" Hub/Rotor - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Q&A: Will Manual Reverse Lockout Work With Demco DA16
- Q&A: Solution for B and W Turnoverball Gooseneck Rusting in 2012 GMC Sierra 2500
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Shop: Suspension Enhancement
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: How to Choose a Trailer Brake Controller
on Accessories and Parts
