2017 Keystone Montana M-3160 RL Leaf Spring U-Bolt Torque Rating

Question

Question:

I need to torque the UBolts on my 2017 3160RL Montana 5th wheel, Axel to leaf. spring Ubolt I need to find the torque value for them. I dont know the size of the ubolt or how to figure it out, do i just measure the the outside diameter

asked by: Clinton V

0

Expert Reply:

Your 2017 Keystone Montana M-3160 RL will have 7K axles which means you'll have a U-Bolt kit similar to CE Smith U-Bolt Kit # CE23003 which needs to be torque to between 45 ft/lbs - 70 ft/lbs.

expert reply by: Jon G

0

Answer 1

Yes, but the orientation of how the regulator is mounted will matter because the vents on the regulator will need to always be facing down to prevent them from getting clogged. If you plan on mounting the regulator horizontally or vertically…

view full answer...

Answer 2

The torque requirements for leaf spring u-bolts depend on the diameter of the u-bolts that are being used. If the gross weight of your tandem axle trailer is 7,000 lbs, then you likely have two 3,500 lb axles. Typically 1/2 inch diameter u-bolts are…

view full answer...

Answer 3

Lithium batteries require a higher charging voltage than standard batteries which a 12 volt trailer accessory source would not be able to provide. So while a lithium battery would do a great job it wouldn't be able to be charged when towing so a…

view full answer...

Answer 4

Hey James! Is it the Lance 295 or 2295? Assuming you have 7k axles with a 3" diameter the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers #RM-2460-2570 will fit. When I tried to look up the 295 I only found the 2295 which…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

2017 Keystone Montana M-3160 RL Leaf Spring U-Bolt Torque Rating

Product Page this Question was Asked From

Continue Researching