Thread Size on DLB Series Brake Winch Ratcheting Replacement Handle

Question

Question:

What size are the internal threads on this handle?

asked by: Tim

0

Expert Reply:

The thread size on the DLB Series Brake Winch Ratcheting Replacement Handle # DL70347 is 5/8”-11.

expert reply by: Robin H

0

Answer 1

Yes the Dutton-Lainson Hand Winch w/ Automatic Brake #DL14958 would work great to replace the Shelby you have now on your boat lift winch.

view full answer...

Answer 2

As long as your winch is a Dutton Lainson B series winch, you can use the #DL6456 socket on it. The socket fits in 1/2" drill and measures 13/16" x 13/16" (outside). The number that you mentioned is just a number used to identify the…

view full answer...

Answer 3

We can help you with a winch but not with a large wheel like in the picture you mentioned. They have several winches designed for boat lifts and those winches are compatible with the big wheel you mentioned. These include the following: Heavy Duty…

view full answer...

Answer 4

For your 1,500 lb boat and a boat lift, the winch I recommend is the Dutton-Lainson Hand Winch #DL14958. This will work perfectly with your boat lift, and I have added a photo a customer sent in of this winch being used on their boat lift. It has a…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Thread Size on DLB Series Brake Winch Ratcheting Replacement Handle

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching