Correct Timbren Suspension Enhancement for the Front & Rear for a 2008 Jayco Melbourne 29D

Updated 11/27/2023 | Published 11/25/2023

Products Featured in This Question

Timbren Front Suspension Enhancement System

(715)

$269.36

Air Lift Load Controller II Compressor System for Air Helper Springs - Single Path

(55)

$297.62

Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle

(1414)

$531.57

Timbren Rear Suspension Enhancement System

(6610)

$398.07

Question:

I have a 2008 Jayco Melbourne 29D with a Ford E-450 chasis and V-10 motor and GVWR of 14,500 lbs with factory installed bump stops. Could you provide me with the correct part numbers for the Timbren front and rear Suspension Enhancement System for my motorhome. Also please provided correct part number for Airlift Load Lifter 5000 Ultimate Air Helper Springs should I decide to go that route. Do you recommend Timbrens or Load Lifters for the rear? I only flat tow with this motorhome. Do you sell an on board air compressor for the Load Lifters? If so please provide part number. Thanks

asked by: Frank R

Expert Reply:

For your 2008 Jayco Melbourne 29D motorhome, you'll want the Timbren Front Suspension Enhancement System # TFEF350UH for the front and # TFERSD for the rear.

If you decide to go with the AirLift 5000 Ultimate Air Springs, then you're going to want the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers # AL88242 with the air compressor kit # AL25592.

If it were up to me I'd probably go with the Timbrens for just based on the fact that there is no hassle with air lines and compressors and they're more affordable than air springs. The only thing you'd lose going with Timbren's is the adjustability that air springs provide.

expert reply by: Bryce D