Replacement Options For a TST TPMS Sensor with a Cracked Cap

Question

Question:

Can you sell just the caps for TST TMPS wheel sensors? One cracked after a stone strike.

asked by: Kevin L

0

Expert Reply:

We do not have just the cap for TST TPMS sensors, and I am not aware of just the cap being available at all.

For replacement options we have the Brass Tire Sensors for TST TPMS # TST-507-RV-S2 and the Flow Through Tire Sensors for TST TPMS # TST-507-FT-S2.

expert reply by: Scott S

0

Answer 1

Hey JV, thanks for reaching out. What you’re running into is almost always a valve stem / TPMS compatibility issue, not that the sensors won’t tighten enough. Those TST sensors seal on the flat face of the valve stem using an O-ring, not by cranking…

view full answer...

Answer 2

Hey Dave, they sure are! We carry the flow through, cap style and the internal sensors for the TST TPMS. It sounds like you are needing the cap style sensors. How many are you needing? We have a two pack and four pack. Take a look at the following: -…

view full answer...

Answer 3

Thanks for the picture and information Sandra. The correct replacement sensor for your TST 507 TPMS system is the Replacement E22 Flow Through Sensor for TST 507 Series item #TST67FR. I think you mean rubber valve stem and yes this sensor will work…

view full answer...

Answer 4

According to Curt their Front Receiver #C31017 will not fit due to a different bumper. I did see where one person said they were able to make it fit but had to do some grinding to make it fit. Because of this you would be best to go with the…

view full answer...

Answer 5

We do have a couple of possible options for front mount hitches for your 2008 Dodge Ram 3500 Mega Cab. You can use #65046. There is some minor drilling required, see instructions, but you will likely not have to do any trimming. I have included a…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

Hey Jay, yes the Draw Tite front hitch part #65046 that you referenced is correct for your 2007 Dodge Ram SLT quad cab 4x4 as long as it's a 2500/3500. If instead you had a 1500 you would want the Curt front hitch part #31320. What are you…

view full answer...

Answer 8

Hey Todd, welcome back! Using the TorkLift StableLoad Suspension Upgrade w Quick-Disconnect item #TLA7311S and installing the SuperSprings SuperSway Stops item #SS75GR will definitely help with sway. They're going to prop up your leaf springs and…

view full answer...

Answer 9

Hey Terry! I have some awesome news for you. The B&W Turnoverball #BWGNRK1313 will absolutely, 100% fit and work for your 2012 Ram 3500 Diesel Mega Cab. In fact, this particular model is specifically designed for the diesel engine models of your…

view full answer...

Answer 10

Hey Adam! Yes, the Trailer Hub and Drum Assembly #TRU66AV will work as a replacement on your axle. This fits the standard #84 spindle found on 3,500 lb axles and has a 5 on 4-1/2 bolt pattern. Then for replacement brakes you can use the etrailer…

view full answer...

Answer 11

Hello Zack, Yes, the #C15704 and #C15809 are very similar. The difference between the 2 is going to be ground clearance. The #C15809 hangs lower and is going to give you around 3" less of ground clearance. The #C15704 sits a little higher…

view full answer...

Answer 12

Since your factory hitch is bolted on and not welded on the correct Torklift hitch is the #TLD1102 and not the part.

view full answer...

Replacement Options For a TST TPMS Sensor with a Cracked Cap

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching