What Is The Gray Wire Harness For With An Atwood Air Command RV Air Conditioner System
Published 07/24/2023
Question:
I am installing the Dometic/Atwood air command model #15028. I want to know what the thin Grey wire with the 4 conductors are used for. It has a small black connector on the end. Thanks
asked by: Fred
Helpful Expert Reply:
The small gray wire harness you're referencing is the connection between the controller of the Atwood system and the wall thermostat. They give you a pretty good amount of wire in case you have a larger run to where you're wanting to install the thermostat. I typically just wind up the excess and zip-tie it into a bundle up in the ceiling with the condenser unit so it's tucked out of the way.
Product Page this Question was Asked From
Replacement Wireless Remote Control for Air Command Rooftop RV Air Conditioners
- Accessories and Parts
- RV Air Conditioners
- Remote Control
- Atwood
more information >
Continue Researching
- Shop: Advent Air RV Air Conditioner System - Single Zone - 15,000 Btu - White - R32
- Q&A: Disconnecting Wall Thermostat of Atwood Air Command Rooftop RV Air Conditioner
- Search Results: rv air conditioners
- Q&A: What Hardware Is Needed To Install An Advent Air Replacement RV Air Conditioner
- Q&A: How to Use Lithium Batteries With a PD4060K Converter/Panel That Does Not Have the Li Switch
- Q&A: Replacement Sink Drain And How To Determine The Correct Sizing
- Q&A: Replacement Parts for Dometic Atwood 15028 Air Command Air Conditioner
- Q&A: Replacement Thermostat Option For An Atwood Air Command RV Air Conditioner
- Q&A: How Long is Warranty on Cummins Onan Quiet Series Onboard RV Generator