Disconnecting Wall Thermostat of Atwood Air Command Rooftop RV Air Conditioner

Question

Question:

How do i remove the wall thermostat Atwood air command

asked by: Brad

1

Helpful Expert Reply:

Wall Thermostats like the Replacement Digital Wall-Mounted Thermostat for Air Command Rooftop RV Air Conditioners - Ducted # AT15029 have a cover that you gently pry off (2 tabs at top and 2 on bottom) and then 3 screws that attach the unit to the wall. Removing the unit will be easy by removing these screws and then disconnecting the wiring harness.

expert reply by: Jason S

1

click to enlarge

Answer 1

The small gray wire harness you're referencing is the connection between the controller of the Atwood system and the wall thermostat. They give you a pretty good amount of wire in case you have a larger run to where you're wanting to install…

view full answer...

Answer 2

The hardware it's referring to are the four bolts that clamp the rooftop condenser unit to the air distribution box inside the trailer. We usually just reuse the bolts from the previous unit during the installation of the new unit #ADV56FR.…

view full answer...

Answer 3

The condenser unit for the Advent Air RV Air Conditioner w/ Air Distribution Box and Wall Thermostat #ADV94FR requires 115v service and the thermostat requires 12v service to properly operate. If all of your wiring is correct, as you stated, then…

view full answer...

Answer 4

With all Atwood products slowly being phased out the only option currently would be to replace the air distribution box you have with part #AT15021, which has the thermostat built into it. There aren't any other thermostats to my knowledge that…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…

view full answer...

Answer 11

Hey Lars, welcome back! I can indeed confirm that the Furrion Variable Speed Chill Cube air conditioner with a heat pump is indeed really happening. They are currently available for order (02/04/26) and will be shipped out towards the middle of next…

view full answer...

Answer 12

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Disconnecting Wall Thermostat of Atwood Air Command Rooftop RV Air Conditioner

Continue Researching