Will SumoSprings Solo Custom Helper Springs Work On a Lifted 2014 Ram 1500

Question

Question:

Can I install sumo springs on a ram1500 2014 it has a 4 inch suspension lift ?do they make adapters for this application for sumo springs if needed?

asked by: Adrian F

0

Expert Reply:

I do have an option for your 2014 Ram 1500 but SumoSprings Solo Custom Helper Springs won't work well as there are no spacers offered for these to account for lifted vehicles. That said, there are spacers offered for the Timbren Rear Suspension Enhancement System part # TDR1500DQ which are very similar to the SumoSprings but offer more support. In order to compensate for the lift you'll need a few of the Timbren Spacers, part # TA25722-90P00 for 1/2" or part # A25723-90AH00 for 1". Please note, you may need to modify the spacers slightly to fit with the factory jounce spring cups and or purchase longer hardware.

expert reply by: Conner L

0

Answer 1

Hey Tommy, you would choose the blue SumoSprings #SS46PV for lighter loads, daily driving, and a softer ride, ideal for occasional towing. While black SumoSprings #SS66PV are better for heavier trucks, frequent towing, and consistent loads, offering…

view full answer...

Answer 2

Hey Joshua! All of the SumoSprings like #SS46PV are designed to fit the Tundra at stock height. SuperSprings does not offer additional spacers to make up for the height difference so these won't work on your Tundra TRD with the lift. What you can…

view full answer...

Answer 3

Hey Joe! SumoSprings doesn't have an option for additional spacers so they will not work with your lift. The gap between the springs and the frame would be too much so they would never engage. If you don't want air bags the Timbren SES #T45MR…

view full answer...

Answer 4

Hello again Monty; I would get the black SumoSprings Custom Helper Springs #SS66PV. These have a capacity of 1,800 lbs so it gives you a bit over the blue without overdoing it. SumoSprings are a great choice if you don't want to go with the air…

view full answer...

Answer 5

Hello Brandon, thanks for reaching out. SumoSpring actually does not make spacers for the Solo Custom Helper Springs like the #SS46EV you mentioned. That said, we do still have spacers that will work for this, the Timbren Spacer part #A25723-90AH00…

view full answer...

Answer 6

I do have an option for you but SuperSprings does not offer any additional spacers for the SumoSprings Trailer Helper Springs part #SS26MV. That said, we do still have spacers that will work for this, the Timbren Spacer part #A25723-90AH00 for…

view full answer...

Answer 7

Hey Kirk, for the SumoSprings kit part #SS46PV that fits your 2024 Toyota Tundra you'd need to use the Timbren spacer blocks part #A25723-90AH00 to take up that extra space created by the lift. You'd need 4 of these per side as these are 1…

view full answer...

Answer 8

It's going to vary some from vehicle to vehicle just because of how your truck rides. However, I reached out to SuperSprings and they told me that a half inch to an inch of clearance between the spring and the frame is fairly standard. The…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Will SumoSprings Solo Custom Helper Springs Work On a Lifted 2014 Ram 1500

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching