Hitch Pin Location for Curt and Draw-Tite Trailer Hitches on a 2022 Ford Bronco

Published 10/10/2022

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(167)

$111.43

Question:

22 Ford Bronco 2DR Sasquatch Can you tell me exactly how much longer this receiver is vs the Curt C76WR? My Bronco has a swing out rear door and I need exact measurements to ensure the swing out of my rear door has enough room to clear the cargo box on my trailer. Thank you.

asked by: TJ

Expert Reply:

The center of the hitch pin hole for the Draw-Tite Max-Frame Trailer Hitch Receiver # DT37GR is 6" further out than the center of the hitch pin hole for the Curt Trailer Hitch Receiver # C76WR. Since the hitch pin hole determines where your accessory will be sitting this is the dimension you want to take note of as opposed to the end of the receiver tube.

I went and measured the Curt hitch and from the outermost mounting plate that installs on your 2022 Ford Bronco to the center of the hitch pin hole is 1" (see attached photo) which means the Draw-Tite hitch pin hole is 7" from the frame of your vehicle (see attached photo).

You can use these dimensions to see where exactly your cargo box will be sitting behind your vehicle. Attached are installation videos of both hitches on a 2022 Bronco for you to check out.

expert reply by: Jon G