Will Curt Trailer Hitch # C15302 Interfere With Under Bed Spare Tire on 2010 Silverado 2500 6.5 Bed  

When installing the Curt hitch part #C15302 you do need to reuse the factory 14 mm bolts that the factory hitch was using but since you have lost yours you could get replacements from a dealer or find matching bolts at a hardware store.

The receiver tube on the Curt Class V hitch #C15302 does not have any reinforcement around the hitch pin hole. I went to our warehouse and checked this hitch to be sure. When this feature is included on a hitch it will usually be easy to see since it…

For your 2002 Chevy Silverado you will need to go with a hitch that will fit trucks that do have a factory trailer hitch. For that you would want the Draw Tite hitch part #41944 which will fit your truck once you remove the factory hitch. This…

The Curt hitch part #C15302 that you referenced does not come with a trailer wiring bracket. You would just need to order the part #PK12711U along with it. I attached an install video for the bracket for you to check out as well.

When it comes to a class V hitch that would work on your 2004 Chevrolet Silverado The Curt Trailer Hitch Receiver - Custom Fit - Class V - 2 inch #C15302 is confirmed to fit your vehicle. It has a maximum gross trailer towing weight up to 16,000…

The Curt Hitch part #C15302 will fit very tight to your rear bumper. It would be hard for me to venture a guess as to how much higher it would sit than your factory hitch. But I can give you a way for you to figure it out. When installed, the #C15302…

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

In regards to the Curt Trailer Hitch Receiver part #C15302 which is a fit for a 2001 Chevrolet Silverado 2500 HD - 6-1/2 Foot Bed, there are only two factory weld nuts in the frame which get reused, they are the two closest to the bumper. The other…

Yes, the Curt Trailer Hitch Receiver #C15302 does not have the bolt holes that also secure it to the bumper on your 2009 Chevrolet Silverado 2500HD with the short bed. This is fine as the construction for this receiver is much stronger than that on…

The biggest difference will be capacity. The Curt Hitch part #C15302 that you referenced is on the high end of the capacity spectrum. It's a Class V hitch that has the following capacities: Maximum gross trailer weight: 16,000 lbs Maximum GTW…

The correct Curt Class V Trailer Hitch Receiver for a 2006 Chevrolet Silverado 2500 with 6-1/2' bed is part #C15302, not part #C15312 which is for models with an 8' bed.

The bolt holes on the Curt Trailer Hitch Receiver #C15302 sit across from each other 39" on center and are separated front to back by 7-1/2" on center. This is a custom fit for the following vehicles: 2008 - 2010 GMC Sierra 2500 - 6-1/2…